SuperMotors SuperMotors SUPERMOTORS Search — try “orange Bronco on 35s”
Join
Home/ Registry/ Ford/ Crown Victoria/ 1992–1997/ “Vicky (totalled & shredded)”/ Tachometer supermotors.net/registry/6098/25632

Album section

Tachometer

From 1994 Ford Crown Victoria “Vicky (totalled & shredded)” — documented by Steve83.

11 photos
← Back to this vehicle
1994 Ford Crown Victoria - This is where I plan to mount the tachometer, but I haven't decided if I'll cut out the entire clock panel & replace it with a black steel… 1994 Ford Crown Victoria - I ordered this Cyberdyne 2" Digital Tach with memory & FRPP Tach Driver from Summit for ~$140. I would have preferred a rectangular bezel &… 1994 Ford Crown Victoria - FRPP M-17361-A200 is $70 from Summit, and includes Scotch-type tap connectors, but I won't be using them. I prefer solder, or crimp connect… 1994 Ford Crown Victoria - The tach driver is semi-permanently integrated into the EEC harness. The green wire will go thru pin 7 of C102 and into the dash harness, w… 1994 Ford Crown Victoria - While removing the dash finisher, I noticed a possible new location for the clock, so I did some rough cutting to test fit it. 1994 Ford Crown Victoria - It fit well, even without fasteners, so I decided to put it here permanently. The wires reach without modification, and there's just enough… 1994 Ford Crown Victoria - The reflection of the camera in the clock lens is a distraction, and the photo makes the edges of the holes look rougher than they are. It… 1994 Ford Crown Victoria - The only 4-wire connector I had handy was for a trailer, but it works. The memory (blue) is shorted to ground by its button, so 4 is enough… 1994 Ford Crown Victoria - I used a scrap of 16ga. steel plate to make a mounting panel. A palm sander smoothed it out in no time. I have the switch threaded directly… 1994 Ford Crown Victoria - I just used some cheap flat black spray paint, but I might redo it someday. The sides of the plate wrap over the 2 verticals in the dash ve… 1994 Ford Crown Victoria - I probably could have done a little better, but I don't like the look of the display. I've pulled it out, and it's for sale now. UPDATE: Af…