BodynTrailer.jpg 3749 hits | 88.98 KB | Posted: 1/1/05 SOLD Body tub, title, & camper shell. Frame & trailer for sale as-is. The loose parts inside are a...
96 Stripped.JPG 2366 hits | 67.16 KB | Posted: 7/7/03 The night I bought it
96 Side.JPG 4837 hits | 109.5 KB | Posted: 7/7/03 SOLD body tub, title, & camper shell
96 Side R.JPG 2444 hits | 113.63 KB | Posted: 7/11/03 SOLD body tub, title, & camper shell
96 LR Quarter.JPG 2177 hits | 82.37 KB | Posted: 7/11/03 SOLD body tub, title, & camper shell
CPS.JPG 1555 hits | 83.68 KB | Posted: 7/7/03 The MAF engine uses a Crank Position Sensor visible in the gap behind the smog-pump-delete pulley.
...
Dash Rear R.JPG 2639 hits | 101.98 KB | Posted: 7/11/03 After lowering the column, removing the big Aluminum casting, unbolting the 2 large connectors under...
DashMounts.jpg 1732 hits | 79.17 KB | Posted: 7/11/03 '80-91 trucks don't have the rectangular bracket around the EEC, and their pedal bracket is cast Alu...
The module I MISlabelled as "Airbag" is actually the Wiper Control Modu...
Timing Pointer.JPG 3165 hits | 102.12 KB | Posted: 7/11/03 Timing Pointer & CKP/CPS (misfire) sensor used only on OBD-II engines. The lower L pulley is a fact...
Sticker Public.jpg 2471 hits | 74.82 KB | Posted: 7/11/03 The check digit & SN have been edited, but all the VIN coding & build codes are true.
Firewall Ventilation.JPG 1632 hits | 76.32 KB | Posted: 7/11/03 The opening at the R edge of the firewall (L in the pic) is the fresh air from the cowl above; the n...
Venitlation Bolt.jpg 1926 hits | 86.68 KB | Posted: 7/11/03 The fresh-air intake is the dark hole with the loose bolts beside it. The top opens into the wiper ...
FrontParts2.jpg 1593 hits | 103.22 KB | Posted: 9/21/04 SOLD Core support
Harness Cut.JPG 1555 hits | 92.31 KB | Posted: 12/24/04 The thieves had a tamper T-40 to unbolt the camper shell, but they apparently didn't have a 10mm to ...
Harness Fix1.JPG 1672 hits | 104.67 KB | Posted: 12/24/04 I stripped all the wires & tinned the ends.
Harness Fix2.JPG 2175 hits | 96.96 KB | Posted: 12/24/04 The 2 shields went back, and all the joints were covered in heat-shrink.
Harness Fixed.JPG 1637 hits | 99.91 KB | Posted: 12/24/04 Good as new!
Harness Loom.JPG 1327 hits | 91.24 KB | Posted: 12/24/04 The split loom cover only has a slight bulge where all the wires are joined.
Harness Repaired.JPG 1489 hits | 99.85 KB | Posted: 12/24/04 The repair is almost invisible.
Haul Tub 1.jpg 1268 hits | 92.65 KB | Posted: 1/1/05 I had to load the body alone & in a hurry, after pulling the engine & front clip a week before. I b...
Haul Tub 2.jpg 1371 hits | 81.25 KB | Posted: 1/1/05 It's barely supported by 2 jack stands in back, & a broken scissor jack in front. When I start pull...
Haul Tub 3.jpg 1386 hits | 108.67 KB | Posted: 1/1/05 It's ready to fall...
Haul Tub 4.jpg 1200 hits | 74.91 KB | Posted: 1/1/05 Nothin' to it.
Brake Lines 4WABS.JPG 1061 hits | 79.45 KB | Posted: 12/31/04 SOLD 5 of the 6 brake line sections for a '93-96 Bronco. The rear section is identical to '87-92, a...
Crate 14.JPG 2967 hits | 63.44 KB | Posted: 1/3/05 SOLD Yes, that's a complete ready-to-run 5.8L engine (& a few other odd parts) in a LARGE crate on a...
Crate 15.JPG 2155 hits | 37.63 KB | Posted: 1/3/05 SOLD The blurry ones were with the flash turned off.
Crate 19.JPG 1876 hits | 41.06 KB | Posted: 1/3/05 SOLDThe blurry ones were with the flash turned off.
Crate 17.JPG 1468 hits | 31.44 KB | Posted: 1/3/05 SOLD The dark ones were with the flash.
58L text.jpg 1749 hits | 72.36 KB | Posted: 10/3/04 SOLD 5.8L MAF engine COMPLETE: truck was stolen with ~60Kmi running perfectly, stripped, then recove...