02 TailOff.JPG 691 hits | 56.51 KB | Posted: 4/17/05 Tailhousing removed. With the transmission tilted up, no fluid was lost, and the gasket remained in...
04LinePort.jpg 400 hits | 63.55 KB | Posted: 4/17/05 The LINE port is at the back of the bellhousing on the L side.
05 Bushing.JPG 465 hits | 40.31 KB | Posted: 4/17/05 The tip of the driveshaft slip yoke is reduced, so it appears loose in the bushing.
The green pla...
06 Shaft.JPG 389 hits | 53.32 KB | Posted: 4/17/05 If your gasket has to be replace (I reused mine), buy F7AZ-7086-A $3.16 .
07Short20.jpg 363 hits | 38.56 KB | Posted: 4/17/05 The TCCoA article recommends an 18" tube, but this 20" one is obviously short. I used a 30" line.
08DrilledBent.jpg 414 hits | 46.91 KB | Posted: 4/17/05 I drilled too far forward - I should have drilled in the dimple of the casting. Considering the rot...
09Bushing.jpg 398 hits | 51.75 KB | Posted: 4/17/05 I almost missed the bushing.
10Elbow.jpg 326 hits | 43.23 KB | Posted: 4/17/05 After drilling, tapping, grinding, & sanding, I rinsed the tailhousing thoroughly with carb cleaner ...
15Shifter.jpg 283 hits | 46.18 KB | Posted: 4/17/05 Finished installed view of the shifter. There is no interference.
16 Below.JPG 298 hits | 68.09 KB | Posted: 4/17/05 Finished installed view of the shifter from below. There is no interference.
17 Leak.JPG 575 hits | 42.51 KB | Posted: 5/16/05 Fluid leaks out of the slip-yoke's vent hole in the center behind the U-joint, and drips off the bot...
18 RightStuff.JPG 381 hits | 32.35 KB | Posted: 5/16/05 Since I couldn't really seal the vent hole with the U-joint in place, I just made a bridge of sealan...
PanDrain.JPG 1127 hits | 72.18 KB | Posted: 6/2/05 After a few hundred miles, I dropped the pan, changed the filter & gasket (it was leaking), and adde...
Forced Lube
