FordExcursions.com Forums
E. Long
 
 |
• Subscriber since 1/1/2001 |
|
• Atlanta, GA, USA |
|
• Registered on 1/23/2001 |
|
• 2,229 posts |
• 1 Vehicle
|
|
|
JohnBoy
 |
|
• DFW, TX, USA |
|
• Registered on 9/3/2002 |
|
• 972 posts |
• 2 Vehicles
|
|
 Posted:1/24/2005 12:47 |
|
|
COUPLE CLUB !?!?!?!!? 
THAT thread title will get some readership for sure !!! 
Great article on the radius rods...
one question...
since I don't have a torch, is there a way to get the cuts done and THEN i can finish the install ?
or is it a only in this order process ?
Thanks 1
JohnBoy
2005 6.0L 4x4 Eddie Bauer Ex
2003 6.0L 4x4 Limited Ex - traded in (BooHoo )
"The Republicans should back off and let men marry men, women marry women, and legalize abortion. In three generations there would be no Democrats." |
|
E. Long
|
• Subscriber since 1/1/2001 |
|
• Atlanta, GA, USA |
|
• Registered on 1/23/2001 |
|
• 2,229 posts |
• 1 Vehicle
|
|
|
Posted:1/24/2005 13:17 |
|
|
| Quote: | COUPLE CLUB !?!?!?!!?
THAT thread title will get some readership for sure !!! |
Leave it to a Texan to read into the topic!!!
| Quote: | Great article on the radius rods...
one question...
since I don't have a torch, is there a way to get the cuts done and THEN i can finish the install ?
or is it a only in this order process ? |
I'll respond here, hopefully LANDYOT will, too.
I would think it'd be perfectly fine to get the cuts done at a local shop and then drive her home to finish the install yourself. Without the traction bars, the axle wrap will be amplified, so just make sure to keep her off the high-HP setting on that thar chip yawl have!!
-Eric
'67 Galaxie 500 - 390 FE, .030" over, FE to AOD adapter, disc brake conversion. The Daily Driver.
'00 Excursion - 7.3L PSD, LANDYOT Gen-II Radius Rods, Factory Tech Valve Body, 200K+ miles and going |
|
|
|
