SuperMotors SuperMotors SUPERMOTORS Search — try “orange Bronco on 35s”
Join
Home/ Registry/ Ford/ Bronco/ 1992–1996/ “Zak the Bronc”/ New Saginaw Pump supermotors.net/registry/1493/20633

Album section

New Saginaw Pump

From 1996 Ford Bronco “Zak the Bronc” — documented by David Couch.

14 photos
← Back to this vehicle
1996 Ford Bronco - Saginaw pump is out of a Chevy 1 ton van and rebuilt by a pro. This pump requires a seperate resivoir. 1996 Ford Bronco - Rear view of pump. 1996 Ford Bronco - A power steering pump assembly is shown with associated parts and tools on a workbench. 1996 Ford Bronco - A power steering pump assembly, likely removed for repair or replacement, sits on a workbench with various tools and supplies. 1996 Ford Bronco - Power steering pump assembly clamped in a vise, ready for work. Part number visible on the pulley. 1996 Ford Bronco - A power steering pump assembly is secured in a vise on a workbench, ready for service. 1996 Ford Bronco - Close-up view of an engine bay, showing an oil filter, radiator, and various hoses and belts. 1996 Ford Bronco - Engine bay view showing accessory drive components including the AC compressor and pulleys. 1996 Ford Bronco - The resivoir is out of a Chevy econo box. Lots of vehicles use a resivoir. If I had it to do over again I would get one out of a Chevy-20 v… 1996 Ford Bronco - Close-up view of the engine bay, focusing on the power steering system components. 1996 Ford Bronco - The front of a green Ford truck is shown with the hood open, revealing the engine and radiator assembly. 1996 Ford Bronco - Picture of the two pulleys that you will usually find on a Saginaw pump. The one on the left is from a Ford e-350 van. The one on the right… 1996 Ford Bronco - The two pulleys again. The GM pulley measures 6.5" diameter. The center hole is .755". 1996 Ford Bronco - The pulley on the left is off of an E-350 van Saginaw pump. It is 5.75" in diameter with the .755 diameter hole. The 5.75" is the same size…