SuperMotors SuperMotors SUPERMOTORS Search — try “orange Bronco on 35s”
Join
1974 Dodge Challenger
Home/ Registry/ Dodge/ Challenger/ 1974 Challenger supermotors.net/registry/16358

1974 Dodge Challenger

documented by Quagmire 22 photos documented since ♡ Follow this build

Photos

1974 Dodge Challenger - A cast-iron pump housing sealed in a clear plastic bag on beige carpet, with red Spanish-language warning text about the pump printed on th… 1974 Dodge Challenger - Melling M-72 oil pump box with part number PC 601-1083 and SP 224-4166. 1974 Dodge Challenger - Aluminum four-hole carburetor spacer plate for a square-bore Holley-pattern carb, laid face-up on carpet with mounting studs installed at t… 1974 Dodge Challenger - Oil filter housing and gasket set are laid out on a carpeted surface. 1974 Dodge Challenger - Holley carburetor with a blue fuel filter attached, resting on a carpeted surface. 1974 Dodge Challenger - Close-up of a carburetor, possibly for a classic car, with a screwdriver adjusting a linkage. 1974 Dodge Challenger - A hand holds a cast-aluminum four-barrel carburetor with gold-cadmium linkage, fitted with a polished chrome fuel line running to a blue an… 1974 Dodge Challenger - Several wheel bearings and seals are laid out on a carpeted surface, with a Supermotors.net watermark at the bottom right. 1974 Dodge Challenger - Engine bearings shown on carpet next to a box. 1974 Dodge Challenger - Eight boxed Clevite 77 engine bearing sets stacked in two rows on carpet, each labeled CB-481 P-10 with part code 2130CP10 and a NASCAR Off… 1974 Dodge Challenger - A chrome license plate frame is shown packaged in bubble wrap and a box, with other car parts visible. 1974 Dodge Challenger - Various metal plugs and threaded fittings are laid out on a piece of cardboard. 1974 Dodge Challenger - Unopened Painless Performance Products alternator wire kit still sealed in its bag, containing coiled red charging wire with crimped ring t… 1974 Dodge Challenger - A collection of valve springs and retainers are laid out inside a cardboard box. 1974 Dodge Challenger - Engine valve keepers are shown scattered on a carpeted surface next to a bag of green parts. 1974 Dodge Challenger - Collection of valve keepers and retainers shown on a carpeted surface. 1974 Dodge Challenger - Small chrome-topped breather filter with a white pleated element and a wire retaining clip, set on light carpet next to a cardboard box and… 1974 Dodge Challenger - A sealed Metro Moulded Parts Super Soft weatherstrip kit in its plastic bag, the coiled black rubber trunk seal labeled TK 64-A/18 for '63-… 1974 Dodge Challenger - An unopened MSD Ignition 8.5mm Super Conductor spark plug wire set in its red checkered box, photographed on carpet. The label lists part n… 1974 Dodge Challenger - Rear-face close-up of a rebuilt alternator lying on carpet, showing the cast aluminum end housing, rectifier diode plate, brass output stud… 1974 Dodge Challenger - A new silver Powermaster alternator with a double-groove V-belt pulley, red and black output wires, and a brass stud, resting on gray carpe… 1974 Dodge Challenger - A matched pair of green-tinted vent window (wing window) glass assemblies laid on bubble wrap over a cardboard box, each still in its stain…
See every Dodge Challenger in the registry

The peanut gallery

No comments yet — be the first to add to the record.

Spotted in the wild

Seen this vehicle at a show or on the trail? Add your shot — the owner approves it onto the record.