SuperMotors SuperMotors SUPERMOTORS Search — try “orange Bronco on 35s”
Freshly welded bare-metal bracket bolted near engine block, rusty pulley and shock visible
Home/ Registry/ Jeep/ Cherokee/ 1984–2001/ 1989 Cherokee supermotors.net/registry/24961

1989 Jeep Cherokee

documented by Adam Parnell 5 photos documented since ♡ Follow this build

The story

Swap was completed by myself at Parnell's Garage in Salisbury, NC

IF you have any questions concerning mounting or swaping a magnum into a xj, MJ feel free to email me... [email protected]

thank you — Adam Parnell

Photos

1989 Jeep Cherokee — The final can be drilled in between the 2 shown for best clearances all around. if lower bolt hole is used st… 1989 Jeep Cherokee — stock driverside mount from v8 ZJ, welded tabs so could lower engine approx an inch. bolts up perfectly and e… Engine mount with rubber isolator, metal bracket, bolts, and hoses. Chain is attached to engine block 1989 Jeep Cherokee — with engine and air hat in place this is the amount of hood clearance. again perfect. 1989 Jeep Cherokee — Vehicle frame and engine bay with some red painted parts. Looks like it's being worked on

The peanut gallery

No comments yet — be the first to add to the record.

Spotted in the wild

Seen this vehicle at a show or on the trail? Add your shot — the owner approves it onto the record.