Steve83 > 1994 Ford Crown Victoria > open folder Power Antenna

Start by finding a good antenna motor & mast, and a dash switch & bezel for your car's year. The da...
01Parts.JPG
1524 hits | 102.4 KB | Posted: 7/24/06
Start by finding a good antenna motor & mast, and a dash switch & bezel for your car's year. The da...
Unscrew the fixed mast. There are tools available for the base nut, but it usually comes loose with...
02Nut.JPG
1536 hits | 74.67 KB | Posted: 7/24/06
Unscrew the fixed mast. There are tools available for the base nut, but it usually comes loose with...
Removing the RF tire makes the job MUCH easier, but if that's not possible, steer fully R.
03WheelWell.JPG
1614 hits | 71.8 KB | Posted: 7/24/06
Removing the RF tire makes the job MUCH easier, but if that's not possible, steer fully R.
Peel the wheelwell forward to expose the gold T-20 Torx screw, and remove it.
04ScrewT20.JPG
1605 hits | 71.51 KB | Posted: 7/24/06
Peel the wheelwell forward to expose the gold T-20 Torx screw, and remove it.
Pull the base down & out of the fender. The black plastic bezel can stay on top of the fender.
05Mast.JPG
1554 hits | 36.23 KB | Posted: 7/24/06
Pull the base down & out of the fender. The black plastic bezel can stay on top of the fender.
Remove the R kick panel for access to the underdash wiring. The antenna wire with the yellow tag ru...
06Kick.JPG
1896 hits | 88.67 KB | Posted: 7/24/06
Remove the R kick panel for access to the underdash wiring. The antenna wire with the yellow tag ru...
Install the motor, pushing it as far UP as possible before tightening the screw, then install the nu...
07Motor.JPG
1622 hits | 37.42 KB | Posted: 7/24/06
Install the motor, pushing it as far UP as possible before tightening the screw, then install the nu...
The unused 2-pin connector with a Green & a Red wire is for the antenna motor. Route the new antenn...
08Wires.JPG
1681 hits | 89.46 KB | Posted: 7/24/06
The unused 2-pin connector with a Green & a Red wire is for the antenna motor. Route the new antenn...
Remove the original radio bezel, connect & install the new switch, and install the new bezel. The a...
09Switch.JPG
1697 hits | 83.42 KB | Posted: 7/24/06
Remove the original radio bezel, connect & install the new switch, and install the new bezel. The a...
Push the insulation & wheelwell back into place, replace the wheel, and you're DONE!
10Ant.JPG
1642 hits | 32.94 KB | Posted: 7/24/06
Push the insulation & wheelwell back into place, replace the wheel, and you're DONE!