SuperMotors SuperMotors SUPERMOTORS Search: try “orange Bronco on 35s”
Join
Home/ Registry/ Mercury/ Tracer/ “sleeper”/ Photo supermotors.net/registry/media/1161800

Hand bending sheet metal with clamps and vise grips on a workben…

Hand bending sheet metal with clamps and vise grips on a workbench
Hand bending sheet metal with clamps and vise grips on a workbenchOriginal file
Hand bending sheet metal with clamps and vise grips on a workbench

2020 compound buildView all 110

Two bent metal brackets with drilled holes on a dark surface Engine bay with blue intercooler and wrench on fender Radiator cap with red lever, marked 'CAUTION' and 'LIFT LEVER TO UNLOCK CAP' Engine bay showing a turbocharger and custom radiator setup. A wrench rests on the radiator Workbench with a locking C-clamp holding metal pieces, green tape, and tools Hammer and clamp on metal fabrication project Dual radiator fans mounted on a custom metal bracket, with tools and tape measure nearby Hand bending sheet metal with clamps and vise grips on a workbench Metal press with clamps holding a bent metal sheet Engine fan and shroud with visible text on a green box Close-up of a blue engine component and exhaust manifold with green tape and purple paper Two aluminum wheel spacers with bolts on a concrete surface. One spacer has a brass-colored bolt next to it Comparison of two wheel studs and spacers Wheel spacer installed over a rusty brake rotor with caliper visible Close-up of a wheel hub showing five lug nuts and a central nut Silver car fender with a wide tire, viewed from the side in a garage 110photos in this albumView all

Sheet metal is being bent and shaped using Irwin QuickGrip clamps and vise grips on a workbench.

AI caption · Photo 222 of 249

Is this accurate? Sign in to help verify it.

Comments

No comments yet.