'lE splines at center of clutch disc with a thin layer 0': 00 grease. Then move the clutch disc back ng input shaft until disc hub moves on shaft 3 'esistance. DON rs encve any excess grease. .. 9 Clutch and pressure plate to the flywheel. r 2'8 clutch disc using clutch pilot disc (Volk- r special tool no. VW 547) and hand tighten the as attachment bolts. t'e locking tool (VW 558) to flywheel and tighten "reel bolts. Alternate in a diagonal pattern to r' Its evenly. ng torques : :3 pressure plate ......... 20 Nm (15 ft-lb) I and pressure plate versions Iii. neei and pressure plate versions are installed 0 vehicle date of manufacture. Flywheel and it-E versions cannot be interchanged. I. : up to December 1992, the flywheel uses two icmel pins, with a dowel pin diameter of 6 mm rs built from December 1992, the flywheel d, and only one 7 mm (0.28 in.) alignment . -sed. See Fig. 20. e plate . 1 up to December 1992, the clutch pressure : recesses to mate with the two-dowel pin fly- 25 built from December 1992, the pressure plate :ess to mate with the single alignment dowel pin. In Is ssure plate has circular shoulders to help Emceel. See Fig. 21. CLUTcH (020 TRANSMissroiy) 30a-11 NED-0001 Fig. 20. Flywheel used on Cars built from December 1992. Note single dowel pin (arrow). 2 Naoroouz Fig. 21. Clutch pressure plate used on cars built from December 1992 Note single recess for dowel pin (1) and Circular shoule Clers (2), CLUTCH