J REMOVAL AND INSTALLATION (Continued) 1 1. Install lower spri 94134 N-m (70 NOTE: it is important installed with the hea clearance to brake s 12. Position the fron bracket. lnstalit tighten to 70-10 13. Connect the frOI stabilizer bar lin nut to 70-100 N 14. install front from inspect brake h: 06-03. 15. install the front 1 Section 04-04. 16. Lower vehicle a suspension, tigl nut to 163-203 NOTE: When lowering the axle, the axle must be supported on the jack throughout radius arm removal and installation, and must not be permitted to hang by the brake hose. if the length of the brake hose is not sufficient to provide adequate clearance for removal and installation of the spring seat, the front disc brake caliper must be removed from the spindle according to the procedures specified in Section 06-03. After removal, the front disc brake caliper must be placed on the frame or otherwise supported to prevent suspending the front disc brake caliper from the caliper hose. These precautions are absolutely necessary to prevent serious damage to the tube portion of the caliper hose assembly. 10. Lower the axle, remove the lower spring retainer, insulator and spring seat and allow the axle to move forward. 1 1. Remove the two bolts attaching the front axle to radius arm bracket to axle tube. 12. Remove spring retainer, insulator, lower spring seat, and stud. 13. Remove radius arm bracket-to-axle tube bolt. 14. Remove the front axle radius arm bracket. 15. Move the axle forward and remove the radius arm from the axle. Remove the radius arm from the frame bracket. Installation Driving Axle, Fron Refer to Section 05- it? ls'li ll