20130603_211155[1].jpg
329 hits | 60.64 KB | Posted: 2013-06-03
(Posted in: ZX7)

20130603_211133[1].jpg
294 hits | 80.26 KB | Posted: 2013-06-03
(Posted in: ZX7)

20130524_202119.jpg
507 hits | 99.18 KB | Posted: 2013-05-24
(Posted in: ZX7)

S6300904.JPG
243 hits | 97.58 KB | Posted: 2012-06-30
(Posted in: bent exhaust pipe)

S6300903.JPG
221 hits | 99.54 KB | Posted: 2012-06-30
(Posted in: bent exhaust pipe)

S6300902.JPG
237 hits | 96.21 KB | Posted: 2012-06-30
(Posted in: bent exhaust pipe)

S6300904.JPG
339 hits | 97.58 KB | Posted: 2012-06-17
Bent tailpipe 3...
(Posted in: Work in progress)

S6300903.JPG
279 hits | 99.54 KB | Posted: 2012-06-17
Bent tailpipe 2...
(Posted in: Work in progress)

S6300902.JPG
261 hits | 96.21 KB | Posted: 2012-06-17
Bent tailpipe 1...
(Posted in: Work in progress)

S6300892.JPG
247 hits | 86.52 KB | Posted: 2012-04-05
(Posted in: Seats)

S6300612.JPG
437 hits | 99.18 KB | Posted: 2011-06-12
A big radiator needs big fans...
(Posted in: Work in progress)

S6300611.JPG
401 hits | 75.58 KB | Posted: 2011-06-12
Battery side view of cut-out....
(Posted in: Work in progress)

S6300610.JPG
406 hits | 89.6 KB | Posted: 2011-06-12
The 38" radiator fits between the stock supports...
(Posted in: Work in progress)

S6300609.JPG
381 hits | 91.79 KB | Posted: 2011-06-12
Cut an inch deep section out of the upper core support...
(Posted in: Work in progress)

S6300608.JPG
497 hits | 101.76 KB | Posted: 2011-06-12
38 " radiator in a 33" hole...
(Posted in: Work in progress)

84 Bronco.JPG
727 hits | 91.65 KB | Posted: 2009-04-11
Lift is done, new Duraspark ignition, ran when primed through carb vent but burned fusible link. Not bad after sitting for 10 years in a field....
(Posted in: Work in progress)