2015-03-06 15.11.04.jpg 188 hits | 66.63 KB | Posted: 2015-10-14 Time to focus on the body... (Posted in: Project Phoenix)
2015-01-27 15.19.58.jpg 215 hits | 81.18 KB | Posted: 2015-10-14 Replaced the original bench seat with a freshly reupholstered set of captains chairs from a 1980 Bronco! Had to match them up with the bucket seat mounts from a 79 Bronco... (Posted in: Project Phoenix)
2014-12-19 15.08.06.jpg 162 hits | 85.87 KB | Posted: 2015-10-14 Enging put back on the painter frame... (Posted in: Project Phoenix)
2014-12-23 13.59.39.jpg 154 hits | 56.37 KB | Posted: 2015-10-14 New Deaver leaf springs in the rear as well.... (Posted in: Project Phoenix)
2014-12-19 15.01.36.jpg 171 hits | 85.16 KB | Posted: 2015-10-14 Installing a Deaver Super-Flex coil springs with a 4" lift from BroncoGraveyard. They better flex a lot because they are quite tall! Unloaded they have raised the truck significantly more than 4 inches. We will reserve judgement until the suspension has all of the weight on it.... (Posted in: Project Phoenix)
2014-12-04 15.31.50.jpg 161 hits | 97.84 KB | Posted: 2015-10-14 Cleaned up the motor while it was out. Put a little chrome and paint on it. ... (Posted in: Project Phoenix)
2014-11-21 16.52.36.jpg 199 hits | 50.44 KB | Posted: 2015-10-14 Covered stripped frame with Chassis Saver. This stuff seems to be awesome! Looks like spray on black glass! I am told it is virtually bullet proof. Time will tell.... but I better not get any future rust.... (Posted in: Project Phoenix)
2014-11-12 11.50.22.jpg 118 hits | 57.87 KB | Posted: 2015-10-14 Disassembly is completed and the media blasting started. Used a water blasting with fi8nely crushed glass to keep heat down and minimize any warping that might occur. would NOT recommend it to anyone. Water is too forceful when under enough pressure to remove paint. Ended up warping the roof and had to replace the hood afterward.... (Posted in: Project Phoenix)
2014-11-06 10.55.01.jpg 117 hits | 48.08 KB | Posted: 2015-10-14 Disassembly started and front clip removed... (Posted in: Project Phoenix)
Rear View.jpg 220 hits | 78.6 KB | Posted: 2014-09-01 The beginning of the restoration in all of her camo glory... (Posted in: Project Phoenix)
photo.JPG 418 hits | 66.01 KB | Posted: 2014-09-01 Step 1: had the top soda blaster as the blasting for the body would have been way too aggressive to use on fiberglass. Side trim removed and the interior stripped out. Ready for structural disassembly to begin... (Posted in: Project Phoenix)
