hanger-installed.JPG 688 hits | 70.44 KB | Posted: 2004-06-15 Custom hanger installed.
Passenger side to drivers side exit balances well at this point.
I chose a simmilar point on the drvers side to passenger exit pipe and it does not balance well. I'll either move that one or place two hangers on that pipe.... (Posted in: exhaust)
pipes - complete.JPG 606 hits | 111.69 KB | Posted: 2004-06-15 Fully welded and ready to install... Almost. Still need to tweek a couple things (cut and reweld) but it's going on for now.... (Posted in: exhaust)
trimming.JPG 549 hits | 65.16 KB | Posted: 2004-06-15 Trimming a little off...... (Posted in: exhaust)
drv pipe stage1.JPG 546 hits | 55.26 KB | Posted: 2004-06-15 Pipe from drivers side collector to the cat.... (Posted in: exhaust)
insertion example.JPG 528 hits | 42.2 KB | Posted: 2004-06-15 The OD of the pipe through the bend radius is slightly smaller than the ID of the pipe through the straight section.... (Posted in: exhaust)
deburred end.JPG 534 hits | 65.54 KB | Posted: 2004-06-15 Deburring the interior is easiest with a deburring tool. IExterior with a file. I used a file for both.... (Posted in: exhaust)
stud & bolt.JPG 600 hits | 66.69 KB | Posted: 2004-06-15 header stud and header bolt.
Studs aid in aligning the header while installing. I was only able to use 4 studs on the dirver side. The other four had interference issures with the header primaries.... (Posted in: header install)
