r3.jpg 757 hits | 43.62 KB | Posted: 2006-09-14 The wheel bearing nuts were tightened and backoff a 1/4 of the way. and the adj nut, washer and lock nut done. time to move on to the Warner hubs. ... (Posted in: wheelbearings hubs and rotor)
q3.jpg 807 hits | 49.5 KB | Posted: 2006-09-14 with the rear bearing seal pressed in I had slippped the bearings on the spindle and hand pressed the outer bearing with a tube matching the ID of the inner race. the void inbetween the two bearings was filled with marine bearing grease as was suggested in the forum. ... (Posted in: wheelbearings hubs and rotor)
p3a.jpg 788 hits | 39.22 KB | Posted: 2006-09-14 I had found the spindle to haver some crosed threads to I had to fix that and test the bearing nuts before assembly of rotor/hub to the spindle. ... (Posted in: wheelbearings hubs and rotor)
p3.jpg 799 hits | 44.17 KB | Posted: 2006-09-14 here is the new brake rotor and the rehabed hub with bearings and grease inside. ... (Posted in: wheelbearings hubs and rotor)
o3.jpg 587 hits | 42.32 KB | Posted: 2006-09-14 The lug studs were pressed in. ... (Posted in: wheelbearings hubs and rotor)
n3.jpg 595 hits | 57.41 KB | Posted: 2006-09-14 here is the hub after rehab and it is having the wheel bearing outer races pressed in. ... (Posted in: wheelbearings hubs and rotor)
m3.jpg 505 hits | 64.61 KB | Posted: 2006-09-14 The hub is being saved and the rotor replaced. the hub will be wire brushed and sandblasted taking care not to contaminate or damage the inside. ... (Posted in: wheelbearings hubs and rotor)
L3.jpg 611 hits | 56.05 KB | Posted: 2006-09-14 using the beveled edge inbetween the hub and rotor I separated the two. ... (Posted in: wheelbearings hubs and rotor)
