351 CID,
-custom 2.5inch y-pipe
-3in highflow catco cat
-flowmater 40 series 3inch in 2.5 inch dual out. goes to flat rectangle tips in front of rear tire. one on each side
-130 amp alt,
-york air compressor out of a volvo
this truck spent time in Texas then upstate New York. so it's not in the best shape but it's not bad.
mods
-dual 800CCA batteries
-g3 130 amp alternator
-1/0 gauge wires
-York 210 air compressor, complete OBA system. rear bumper is air tank. gauge mounted in cab.
-4 6inch 130 watt stainless steel lights. mounted on front of soon to be built roof rack
-4ft black firestic CB antenna. mounted to rear bumper
-40 channel CB
-rear bumper, single 4.5in tube w/ receiver, 1/2 in wall steel, it's the air tank (i built)
-rock sliders, 1.5x3 in. 1/4 inch wall. and 1/8 wall round for the steps. (i built)
-front bumper, 1/4 inch plate, holds MileMarker 12000 lb. electric winch, and 1/2 inch plate tow points. (i built)
-painted tail lights black to blend with truck.
-cut-out rear fenders and rear body corners
-6inch eyebrow
-double 5% tint on rear windows
-sound deadening, three layers on tailgate, one layer on all plastic trim from front seats back, one layer on metal body tub sides only, three layers in doors.
-custom (i built) center console, has switch pannel, head unit, cig lighters, OBA hook up, Amps, CB, fire extinguisher, maglight, mounts built in.
-pioneer CD, MP3, satellite radio head unit
-Diamond Audio D 3: 6.5 inch components
-Pioneer 4 channel amp powering those
-1/0 gauge power wires, switches for amp's remote turn on located on switch pannel, amp in center console
-tranny temp and water temp gauges in 2 gauge pod on A pillar. oil pressure and air pressure for OBA along with a clock in the stock radio location
a-pillar gauge pod 2.JPG 359 hits | 52.3 KB | Posted: 2/22/06 i mounted the gauges as low as posible to try to keep them out of my field of vission. no rattling against the dash and very little lost visibility.
door pannel inner before .JPG 340 hits | 68.86 KB | Posted: 11/3/05 door pannel before with stock capet padding sound deadening removed.
door light missing.JPG 333 hits | 35.85 KB | Posted: 11/3/05 something else i need to fix wile everythign is taken apart
147-4779_IMG.JPG 325 hits | 65.69 KB | Posted: 10/17/05 first good stuck. notice the main reason for getting a new rear bumper.
tailgate sound dead.JPG 303 hits | 63.41 KB | Posted: 9/4/05 that's the best pic i could get of the sound deadening in the tailgate.
inner door pannel after peal and seal.JPG 285 hits | 66.31 KB | Posted: 11/3/05 inner door pannel after peal and seal. i might stick the old factory stuff on too. haven't decided yet.
sound deadening door 3.JPG 282 hits | 44.29 KB | Posted: 12/11/05 i didn't get as much sound reduction as i was hoping for. i may try another layer since i have the extra. but that wont be till i have some new door speakers.
