driveshafts10.jpg
1072 hits | 28.1 KB | Posted: 11/30/05
factory u-joints: left=front ds, no zert, right =rear ds w/zert

driveshafts1.jpg
1105 hits | 35.81 KB | Posted: 11/30/05
front ds-top, rear ds, bottom

driveshafts3.jpg
1089 hits | 37.45 KB | Posted: 11/30/05
close-up

driveshafts4.jpg
1102 hits | 43.97 KB | Posted: 11/30/05
front ds- dis-assmbly. remove clips holding rubber boot

driveshafts5.jpg
1259 hits | 38.26 KB | Posted: 11/30/05
clips loosened, separate slip joint

driveshafts11.jpg
1169 hits | 36.33 KB | Posted: 11/30/05
slip-joint, front driveshaft

driveshafts6.jpg
1066 hits | 25.75 KB | Posted: 11/30/05
snap ring holds u-joint cap in yoke

driveshafts7.jpg
1158 hits | 27.06 KB | Posted: 11/30/05
Remove snap ring, use a vise to press out the cap or drive out with a 5/8" socket

driveshafts8.jpg
971 hits | 25.7 KB | Posted: 11/30/05
flip over, remove cap

driveshafts9.jpg
988 hits | 33.8 KB | Posted: 11/30/05
flip over, remove u-joint

driveshafts12.jpg
1084 hits | 31.49 KB | Posted: 11/30/05
CV (constant velocity) joint, rear ds

Academy Oct 08 024.jpg
969 hits | 62.63 KB | Posted: 11/3/08
measuring for square tubing shafts

Academy Oct 08 025.jpg
931 hits | 58.2 KB | Posted: 11/3/08
measuring for square tubing shafts

sqds21.jpg
875 hits | 70.64 KB | Posted: 11/17/08
cutting tubing on power saw

sqds22.jpg
891 hits | 68.29 KB | Posted: 11/17/08
cutting tubing on power saw

sqds25.jpg
984 hits | 77.31 KB | Posted: 11/17/08
old power saw works!

sqds26.jpg
993 hits | 61.1 KB | Posted: 11/17/08
welded 1.5" tubing piece to end yoke

sqds27.jpg
1005 hits | 58.26 KB | Posted: 11/17/08
both pieces of driveshaft

sqds29.jpg
1005 hits | 58.93 KB | Posted: 11/17/08
square driveshaft assembled, 28" long

transxmbrmod 003.jpg
1441 hits | 71.54 KB | Posted: 1/7/09
rear driveshaft installed

transxmbrmod 001.jpg
943 hits | 62.77 KB | Posted: 1/7/09
notched tranny crossmember for front driveshaft

transxmbrmod 009.jpg
981 hits | 63.37 KB | Posted: 1/7/09
stock front driveshaft installed