1985 Ford Bronco
Owner: Tim Bevers         (All of this user's registries on SuperMotors)
From: Portland, OR, U.S.A.        (Other registries in OR)
Year, Make, & Model: 1985 Ford Bronco        (Other Ford Broncos in this club)
Avatar:
Clubs: SuperFord.org        (Other vehicles in this club)
Nickname: Thing 1
Mileage: 98000
Engine: 302 (5.0 EFI)
MSD-6 OffRoad Ignition and Coil
Custom K&N Intake and filter
New wires (8.8mm) and plugs
New cap and Rotor
All new smog equipment
All new filters (gas)
New front and rear fuel pumps

New Excide spiral wrap battery (old one was a deep cycle with a crack in it)
Lots of work with the vacuum system (lots missing and lots just mis-routed)
4 inch tach
Flowmaster Muffler
Hi Flow cat


Drivetrain: 4-Speed w/ granny first
Dana 44 IFS front end
Ford 9" rear (soon to have a locker)
Warn Premium Hubs (drivers side was grenaded)
2" lift in the front (Rough Country springs and @ RS5000 shocks stock dual shock setup)
2.5" blocks (ProComp) in the rear with ProComp springs
Removed the rear sway bar (one mount was broken for it anyway).
Installed ProComp Steering stabilizer
Installed a locker in the Ford 9" rear.

Notes: Current status: Well I traded her years ago. No longer have this one. Turns out she had electrical issues. It would randomly shut down. And randomly work. Who knew. So I traded her off. The issue was a


I got the Bronco with a trade for a laptop from another trade from something that I got for free. I paid for it in the end though. It needed MUCH work, including, full smog system so I could license it, stereo, fuel pumps (yes two, what a pain), new wheels and tired (swampers of course). Now it has also had added a huge winch bumper, a secondary battery, isolator, Painless Wiring seperate circut for accessories, It has 3 sets of offroad lights (KC competition), HiLift Jack mounted inside, CB (Cobra), 102" whip antenna, full gagues (sunpro in a custom mount into the dash), and more that I'm sure I missed here. Soon to come will be either a lift or a solid front axle conversion. Dunno, have to debate and decide on that one.

Update: I isntalled a 2" lift, all new shocks (6 of em), steering stabilizer, and a locker in the 9" rear end. ALong with finishing the high power Alternator (140 amp) project, and completing the dual battery setup (one in the rear)
Last Updated: 8/25/2014
Hits: 8220
Album
Folder Hits Comments Created Updated
folder Bronco beginnings...19007,38601/26/041/26/04
    folder Clean and new tires and wheels.6003,15301/26/041/26/04
folder Winch & Bumper upgrade7003,50101/26/041/26/04
folder Trips000001/26/041/26/04
    folder 1st run in the mud10045701/26/041/26/04
    folder SNOW!6003,66301/26/041/26/04
folder Upgrades000001/26/041/26/04
    folder Ignition and Smog, and electronics.6003,15201/26/041/26/04
Newest Media Files
clean4.jpg
667 hits | 66.34 KB | Posted: 1/26/04

snowb6.jpg
654 hits | 63.91 KB | Posted: 1/26/04

First snow that stuck around here for a few years, so yeah we went a bit crazy. Now if it will only do it again...
snowb5.jpg
623 hits | 67.11 KB | Posted: 1/26/04

Action shot, parking lot + ice + snow = COOKIES!
snowb4.jpg
578 hits | 40.76 KB | Posted: 1/26/04

Ok, so I'm posing. So?
snowb3.jpg
637 hits | 39.51 KB | Posted: 1/26/04

Flexing as much as a stock TTB can with no lift or anything.
snowb2.jpg
566 hits | 47.37 KB | Posted: 1/26/04

Rear bumper dragging a bit here. Starting to think its not going to be around much longer.
snowb1.jpg
605 hits | 48.83 KB | Posted: 1/26/04

Found a loading ramp in the snow. Not too challenging, but fun non-theless.
engine6.jpg
588 hits | 87.25 KB | Posted: 1/26/04

engine5.jpg
571 hits | 91.35 KB | Posted: 1/26/04

You can see the MSD good here. towards the front of the Bronc there a coil from MSD too.
Most Viewed Files
winch.jpg
718 hits | 57.24 KB | Posted: 1/26/04

engine3.jpg
712 hits | 80.05 KB | Posted: 1/26/04

clean4.jpg
667 hits | 66.34 KB | Posted: 1/26/04

bronco_nobump1.jpg
659 hits | 61.88 KB | Posted: 1/26/04

Had to have the local Les Schwab cut off the old bumper and the bolts, they were so rusted on that even after a full day of soaking in PB Blaster they wouldn't come off by hand. So, they brought out the cutting torch.
snowb6.jpg
654 hits | 63.91 KB | Posted: 1/26/04

First snow that stuck around here for a few years, so yeah we went a bit crazy. Now if it will only do it again...
snowb3.jpg
637 hits | 39.51 KB | Posted: 1/26/04

Flexing as much as a stock TTB can with no lift or anything.
snowb5.jpg
623 hits | 67.11 KB | Posted: 1/26/04

Action shot, parking lot + ice + snow = COOKIES!
clean6.jpg
620 hits | 57.06 KB | Posted: 1/26/04

Mmmmm, swampers...
snowb1.jpg
605 hits | 48.83 KB | Posted: 1/26/04

Found a loading ramp in the snow. Not too challenging, but fun non-theless.
Maintenance & Modification Logs
This user hasn't added any log entries, yet.
About SuperMotors | Contact Us | FAQ/Help | Legal
Copyright © 1998-2024 Web Design Solutions, Inc.
All rights reserved. Duplication & reproduction is strictly prohibited.
SuperMotors.net v5.0.2 ChangeLog