SuperMotors SuperMotors SUPERMOTORS Search — try “orange Bronco on 35s”
Join
Home/ Registry/ Ford/ Bronco/ 1980–1986/ “Jezebel”/ Pivot Bushings supermotors.net/registry/6364/52991

Album section

Pivot Bushings

From 1983 Ford Bronco “Jezebel” — documented by michael collins.

8 photos
← Back to this vehicle
1983 Ford Bronco - Here is the stock pivet mount bushing (i was replacing the TTB drop mount so it is not in the picture). 1983 Ford Bronco - Here was the old pivet mount. they tack welded it in place. 1983 Ford Bronco - the old mounts do not come out too easy. i used the drill many holes in the rubber and then an air chisle to push out the center sleave and… 1983 Ford Bronco - I did the bushings on the bronco. i put the jack stand on the outer axle and used the floor jack as a pivot point. 1983 Ford Bronco - Here is the tool you will want to get if you are installing new bushings. i could have used this to pull the old one out but i did not have… 1983 Ford Bronco - This is after i drilled out the rubber and used the air hammer to punch out the shell. 1983 Ford Bronco - Here is the new bushing installed and ready to go in the new mount. 1983 Ford Bronco - Here is a close up of the new bushing.