SuperMotors SuperMotors SUPERMOTORS Search: try “orange Bronco on 35s”
Join
Home/ Registry/ Ford/ Bronco/ 1992–1996/ 1996 Bronco/ Gear & Truss Install supermotors.net/registry/1314/16915

Album section

Gear & Truss Install

From 1996 Ford Bronco, documented by Jer Rizzuto.

14 photos
← Back to this vehicle
1996 Ford Bronco - Truck jacked up just a little. 1996 Ford Bronco - Keith up front taking off the front driveshaft so we can swap yokes to the new D44. Scott in back removing the rear DS 1996 Ford Bronco - An empty 8.8. Keith, Doug, and I all went and ate dinner, Scott had everything tore down in the 20 minutes we were gone. 1996 Ford Bronco - Crushed T-Casr skid plate, and my front driveshaft. 1996 Ford Bronco - Doug getting the D44 all strapped up so we could get the gears in. I had to clean the POS for alomost an hour. 1996 Ford Bronco - This is Dustin doing what he does best (In his mind) SUPERVISING!!!!! Or just sitting on his ass, you decide. 1996 Ford Bronco - On a side note this is the beautiful D60 that Scott is working on. 1996 Ford Bronco - This is what happens when you let Bud do all the hammering while Scott holds it all down. 1996 Ford Bronco - Scott playing with the press. That is the third coolest tool he has. (It Follows by the plasma cutter and the welder of course) 1996 Ford Bronco - This is Bud testing out the durability of Scotts Dana60. 1996 Ford Bronco - This is Mitch (Bronco AZ) and Keith watching porno uuuuhhhhh I mean looking at Roll cage projects. 1996 Ford Bronco - Putting the finishing touches on the gear install on my D44. Doug is just applying the marking compound before it was all done. 1996 Ford Bronco - This is the 8.8 with fresh gears and parts after I put all the spiders and side gears back in. (oh and the x-pin and C-clips too.) 1996 Ford Bronco - This is Scott welding on the 8.8 axle truss.