SuperMotors SuperMotors SUPERMOTORS Search: try “orange Bronco on 35s”
Join
Home/ Registry/ Ford/ Bronco/ 1992-1996/ “Zak the Bronc”/ New Saginaw Pump supermotors.net/registry/1493/20633

Album section

New Saginaw Pump

From 1996 Ford Bronco “Zak the Bronc”, documented by David Couch.

14 photos
← Back to this vehicle
1996 Ford Bronco - Saginaw pump is out of a Chevy 1 ton van and rebuilt by a pro. This pump requires a seperate resivoir. 1996 Ford Bronco - Rear view of pump. 1996 Ford Bronco - A cast aluminum accessory/serpentine bracket with a mounted pulley sits on a green speckled surface, alongside a power steering pump, curve… 1996 Ford Bronco - A disassembled automotive component, likely a power steering pump and mounting bracket assembly, sits on a green speckled surface against w… 1996 Ford Bronco - A cast aluminum accessory/power steering pump bracket mounted in a blue bench vise, with a black serpentine pulley and new pump assembly at… 1996 Ford Bronco - A cast metal accessory bracket sits on a greenish workbench, holding a serpentine pulley with multiple grooves and a black ribbed tensioner… 1996 Ford Bronco - Close-up of an engine bay showing a newly installed serpentine-belt-driven pump with a ribbed pulley and mounting bracket, alongside a red-… 1996 Ford Bronco - Close-up of a newly installed silver aluminum A/C compressor with a yellow label mounted on its bracket in an engine bay, with a black serp… 1996 Ford Bronco - The resivoir is out of a Chevy econo box. Lots of vehicles use a resivoir. If I had it to do over again I would get one out of a Chevy-20 v… 1996 Ford Bronco - Close-up top view of an engine bay showing a black power steering reservoir with embossed 'POWER STEERING DO NOT OVERFILL USE ONLY APPROVED… 1996 Ford Bronco - Front-end view of a green Ford truck/SUV with the grille removed, showing the radiator core support, engine bay hoses, and a newly installe… 1996 Ford Bronco - Picture of the two pulleys that you will usually find on a Saginaw pump. The one on the left is from a Ford e-350 van. The one on the right… 1996 Ford Bronco - The two pulleys again. The GM pulley measures 6.5" diameter. The center hole is .755". 1996 Ford Bronco - The pulley on the left is off of an E-350 van Saginaw pump. It is 5.75" in diameter with the .755 diameter hole. The 5.75" is the same size…