SuperMotors SuperMotors SUPERMOTORS Search: try “orange Bronco on 35s”
Join
Home/ Registry/ Ford/ Bronco/ 1992-1996/ “boss”/ Bracket Recon supermotors.net/registry/15991/63147

Album section

Bracket Recon

From 1996 Ford Bronco “boss”, documented by bossind.

16 photos
← Back to this vehicle
1996 Ford Bronco - A metal tubular bracket or mount, painted dark with surface rust near its lower bends, featuring bolt holes at the top ends and mid-section… 1996 Ford Bronco - Bare-metal tubular roll bar hoop stripped of finish, with small mounting brackets at the upper bends and flat mounting feet, laid on a stai… 1996 Ford Bronco - Bare-metal tubular roll bar hoop lying on a concrete garage floor after being stripped and welded, with flattened drilled mounting tabs at… 1996 Ford Bronco - A pair of fabricated tubular exhaust headers hanging by wire in a shop, freshly welded and in bare metal, in front of an electrical panel a… 1996 Ford Bronco - Bare bent steel tube brackets with welded tabs hang on wires in a shop, raw metal still unpainted before finishing. Behind them are a green… 1996 Ford Bronco - Freshly powder-coated gloss black roll bar tubes and support legs hanging on wire in a shop next to a gray electrical disconnect panel and… 1996 Ford Bronco - Four freshly powder-coated gloss black bent tubular brackets with welded mounting tabs hang on wire hooks in an industrial shop next to an… 1996 Ford Bronco - Four small black-oxide metal clips or retainers laid out on a white shop towel, each a stamped and folded piece with a curved saddle and a… 1996 Ford Bronco - Close-up of a freshly coated glossy black steel bracket with a slotted mounting hole and hooked arms, hanging on a rack in an industrial po… 1996 Ford Bronco - Freshly painted glossy black stamped-steel bracket held up in a shop, with a raised cast part number, a keyhole-shaped slot and a rounded l… 1996 Ford Bronco - Close-up of a gloss-black tubular push bar or grille guard bolted to a bare, surface-rusted bumper support inside a working shop bay. Behin… 1996 Ford Bronco - Underbody detail of a freshly painted black tubular bar, a nerf/rock-slider or side step tube, bolted through brackets to the rocker pinch… 1996 Ford Bronco - A hand uses needle-nose pliers to work a corroded pin on a beige-painted stamped-steel panel with slotted mounting holes, rust blooming aro… 1996 Ford Bronco - A tan interior trim panel stood on edge shows its backside with molded studs and a bare metal reinforcement bracket, resting on a scratched… 1996 Ford Bronco - Two tubular truck brackets laid side by side on a concrete shop floor for comparison: the upper one heavily rusted and pitted with flaking… 1996 Ford Bronco - A pile of zinc-plated stamped steel mounting brackets and flange-head bolts, one bracket cast with a Ford oval part marking, laid out on a…