SuperMotors SuperMotors SUPERMOTORS Search — try “orange Bronco on 35s”
Join
Home/ Registry/ Ford/ Bronco/ 1992–1996/ “The Beast”/ Tow Hook Install supermotors.net/registry/16280/55332

Album section

Tow Hook Install

From 1996 Ford Bronco “The Beast” — documented by Roadkill.

13 photos
← Back to this vehicle
1996 Ford Bronco - This is the front before the hooks were installed. You don't need the ramps, but they do make it easier. 1996 Ford Bronco - I used a white out pen to mark locations for later re-alignment. I forgot to mark the bottom of the braket, but there was a rust line there… 1996 Ford Bronco - Next remove the bumper. 1996 Ford Bronco - Mark and drill the holes then bolt on the hooks. If you drill the hole right, the flat side of the nut will but up agains the edge of the i… 1996 Ford Bronco - This photo shows a tow hitch receiver and shackle, not a specific vehicle model or year. 1996 Ford Bronco - Close-up view of the front tow hitch and tire of a 1996 Ford Bronco. 1996 Ford Bronco - Close-up view of a tow hook mount and bolts, indicating installation or repair work on a vehicle's front end. 1996 Ford Bronco - Here is a shot of both hooks. Only thing left is to mark and cut the bumper to go around the hooks. 1996 Ford Bronco - Here is a shot of both hooks. Only thing left is to mark and cut the bumper to go around the hooks. 1996 Ford Bronco - Here is the completed job. I used a 2" hole saw and a grinder with a cutting wheel to make the cut-outs. This is definately a step where th… 1996 Ford Bronco - Front view of a 1996 Ford Bronco, showing the grille and bumper. 1996 Ford Bronco - A tan Ford truck is parked outside with tools scattered on the ground nearby. 1996 Ford Bronco - A tan Ford F-Series truck navigates a challenging, rocky terrain under a clear blue sky.