SuperMotors SuperMotors SUPERMOTORS Search: try “orange Bronco on 35s”
Join
Home/ Registry/ Ford/ Bronco/ 1992-1996/ “Wookie”/ Clutch Slave Cylinder supermotors.net/registry/27982/86425

Album section

Clutch Slave Cylinder

From 1995 Ford Bronco “Wookie”, documented by flomaster.

13 photos
← Back to this vehicle
1995 Ford Bronco - This is the reason for the wonderful time I spent on Saturday. What is depicted here is the cheap, Chinese piece of cr@p clutch slave cylin… 1995 Ford Bronco - Because I was in a hurry, I left the transfer case attached to the transmission for removal. Because its heavy and hard to stab back in pla… 1995 Ford Bronco - What is depicted here is the new slave cylinder placed in the bellhousing of the transmission. Notice that the old slave cylinder leaked fl… 1995 Ford Bronco - I've cleaned up the old slave cylinder a bit for disassembly. I want to know what makes these things tick. 1995 Ford Bronco - Depicted are the constituent parts of the clutch slave cylinder. I'm not sure about the proper terminology for the parts, but from left to… 1995 Ford Bronco - To remove the piston seal, I used a syringe with some mineral oil in it to force the piston seal out using hydraulic pressure. Despite the… 1995 Ford Bronco - This is the piston. Well, its less of a piston than an extension of the piston. I'm going to call it a "piston follower". The act… 1995 Ford Bronco - Again, its hard to tell from the pictures, but one can see the texture of the bottom portion of this piece. 1995 Ford Bronco - One of the burrs can be plainly seen in the upper "corner" of the piece. Lack of proper surface preparation and poor quality cont… 1995 Ford Bronco - This is the piston seal. The outer surface is supposed to provide a seal on the outer part of the housing, and the inner surface is suppose… 1995 Ford Bronco - The seal is quite flexible. 1995 Ford Bronco - Peering down between the outer housing and inner housing. This is where the seal is installed, and it moves back and forth (up and down in… 1995 Ford Bronco - As one can see in this picture, the burrs have cut into parts of this piston/seal. I also removed quite a bit of what I can only describe a…