SuperMotors SuperMotors SUPERMOTORS Search: try “orange Bronco on 35s”
Join
Home/ Registry/ Ford/ Bronco/ 1992-1996/ 1994 Bronco/ Modification Begins supermotors.net/registry/918/7369

Album section

Modification Begins

From 1994 Ford Bronco, documented by Tom Bachant.

8 photos
← Back to this vehicle
1994 Ford Bronco - Here is the 'Rock slider' that will reinforce my rocker panels. The cutout for the seatbelt bolt was done with an angle grinder. (Wife's Je… 1994 Ford Bronco - Here is the Rock slider installed. The shot is take looking up at the drivers side. 1994 Ford Bronco - I thought I was just sanding off a few rust bubbles. As you can see I got rid of the rust. Now I have a hole. 1994 Ford Bronco - Marking fenders for trimming. 1994 Ford Bronco - Here is the left fender after taping. I have hopefully left enough meat fron and rear to bend it inward. 1994 Ford Bronco - Here is the left side taped for trimming. I had to use a slightly differant angle because of glare. Notice the hole near the front. 1994 Ford Bronco - Here is the right side fender cut out to the tape marking. You can just barely make out the inner fender. There is no turning back now. 1994 Ford Bronco - Here is a shot showing the whole left side. It doesn't look too bad so far. Both sides are trimmed. Now to figure out how I'll finish it.