3, F- 150 4x4 and BrOnC0 ont Shock Absorbers lure 953 front shock rith nitrogen 988 to 93 1 1d 1-3/ 16 inch bore and 3/8 inch bore. Do not l or apply heat to the j and rearward of from r, insert a wrench to r absorber retaining nut. r the hex on the a stud. Remove nut and f the front shock bolt and nut for ation, and nut and ixle installation. isorbers and spring seat. l into the top t(use soap l through and hand start Description Radius Arm (LH) Bolt (Must Be install Direction Shown) Bolt Bolt 433-460 N-m (320-340 Ft-Lb) Bolt (2 Req'd) 2&3 (20-28 Ft-Lb) Front Lower Shooli (RH) Front Lower Shool (LH) Nut and Washer 7 (52-73 Ft~Lb) Stud 328-352 N-n (240-260 Ft-Lb) Lower Spring Se: Front Spring inst Retainer Nut 70-100 N-m (52-74 Ft-Lb) Front Coll Sprin Radius Arm, Bronco and F-150 4x4 Removal Refer to illustrations under Front Spring, F- 150 4x4, Removal and installation. 1. Raise the vehicle and position sate under the frame side rails and 3 im Rotunda Hydraulic Floor Jack 071 equivalent under the axle. 2. Remove the front wheel and tire: to Section 04-04. 3, Disconnect the tram stabilizer II