Home/ Registry/ Mini/ Cooper/ 1961-1971/ 1969 MINI Cooper/ Photo supermotors.net/registry/media/678947

Lathe three-jaw chuck turning a steel bar with a curl of swarf a…

‹ ›

Morris MInor ProjectView all 230

Underside of car floorpan with new welded steel mounting brackets, seen on a hoist

Welded bare-metal patch panels and cut-out in a stripped car bulkhead during fabrication

Welded bare-metal blister on a blue firewall panel surrounded by panel-beating tools

Welding work on the interior floor of a classic car, with tools and a welding mask.

rusted car grille with horizontal bars, green paint showing through rust

Rusted green and brown metal panel with two orange circles highlighting bolts

Service manual page with body alignment diagram and diagonal measurement table for a Morris Minor

Metal lathe chuck holding a rod, with tool post and handle visible

Fabricated aluminum bracket clamped in a red Ironman bench vise on a workbench

Drill press holding a metal part in a vise, with shelves of supplies in the background

Close-up of a metal bracket welded to a rusty vehicle frame, possibly for modification

Metal bracket with nut and bolt on workbench with tools

Interior view of a greasy transmission and drivetrain tunnel with tools and a light

New cast-iron brake master cylinder marked Made in USA in front of its cardboard box

230photos in this albumView all

Close-up of a metal lathe's three-jaw chuck gripping a steel bar being turned down, with a curling chip of swarf peeling off at the cutting tool. The cross-slide handle, toolpost and oily machine ways fill the lower half of the frame.

AI caption October 2008 · Photo 100 of 590

Is this accurate? Sign in to help verify it.

Comments

No comments yet.