New switch in column. Put the two screws in, plus the screw holding down the ground block. It's the little white block just to the left of the hazard switch. Tuck those wires over by the hazard switch in and make sure the switch is flush when you put the two retaining screws back in. At this point, you can put the key in and turn in aux power to test the signals. If all is good, put the steering wheel back

Special thanks to YouTube user Firesupression1 for his video on doing this. Very helpful. http://www.youtube.com/watch?v=Oou2FPEGiLw

Owner caption October 2013 · Photo 62 of 62