S2010010.JPG 850 hits | 87.71 KB | Posted: 2003-12-02 Thow that puppy in there and use a dial indicator with a magnetic base to check for backlash, and paint it up to check for the pattern. Over all a gear swap is pretty basic stuff other than patience.... (Posted in: Gear swap)
bronco gears 007.jpg 827 hits | 88.23 KB | Posted: 2003-12-02 There is the new carrier with the spider gears from the old carrier. The only difference between the carrier that can accept the larger gears and the lower gears is the flange, so the spider gears will swap with no problem.... (Posted in: Gear swap)
bronco gears 006.jpg 995 hits | 97.3 KB | Posted: 2003-12-02 I had to lower my tie rod to get better access to the diff, also make sure to really clean the crap out of the empty housing.... (Posted in: Gear swap)
bronco gears 002.jpg 867 hits | 71.71 KB | Posted: 2003-12-02 Remove the carrier by taking the 4 cap bolts out and yanking the carrier out by its horns!... (Posted in: Gear swap)
bronco gears 001.jpg 999 hits | 81.01 KB | Posted: 2003-12-02 Take diff cover off and remove axle shafts... (Posted in: Gear swap)
driveWayPosing.JPG 773 hits | 83.23 KB | Posted: 2003-12-02 Finally the buckets are moved down and the lift is complete!... (Posted in: SAS)
3inToLow2.jpg 698 hits | 38.69 KB | Posted: 2003-12-01 DOH! 3" to low, this is frustrating...... (Posted in: SAS)
clearAxleShot.jpg 665 hits | 66.08 KB | Posted: 2003-12-01 There it is (Man that trac bar looks tacky)... (Posted in: SAS)
tracBarMount.jpg 527 hits | 61.87 KB | Posted: 2003-12-01 Used the stock mounting position on the axle for now, later I will make a new one once I get a new trac bar... (Posted in: SAS)
tacBarMount2.jpg 534 hits | 63.47 KB | Posted: 2003-12-01 Trac arm mount installed... (Posted in: SAS)
