01Tools.JPG
1041 hits | 68.77 KB | Posted: 4/5/06
This procedure will make accessing the fuel pump or fuel level sender in any fullsize Bronco much ea...

02Welds.JPG
842 hits | 50.04 KB | Posted: 4/5/06
Locate the line of spot welds holding the bed down on the body mount channel. The lip of the channe...

03Welds.JPG
783 hits | 40.53 KB | Posted: 4/5/06
This shows the welds' locations in relation to the lip of the channel. Cut along the back of this l...

04Tape.JPG
783 hits | 58.01 KB | Posted: 4/5/06
The front of the hole (at the back of the channel's lip) should be 26" forward from the back of the ...

05Start.JPG
758 hits | 56.44 KB | Posted: 4/5/06
A 4 1/2" angle grinder with a thin wheel is probably the easiest way to make the initial cuts. But ...

06Cut.JPG
807 hits | 70.42 KB | Posted: 4/5/06
If you use a saw, make SURE you don't puncture the gas tank. Even if it doesn't catch fire, it's st...

07Size.JPG
786 hits | 47.68 KB | Posted: 4/5/06
This is where the hole should be. DO NOT CUT everything out like I did - I'm harvesting the floor f...

08Size.JPG
1075 hits | 54.75 KB | Posted: 4/5/06
This is where the hole should be. DO NOT CUT everything out like I did - I'm harvesting the floor f...

FPAccess.jpg
835 hits | 20.71 KB | Posted: 4/5/06
Installation of fuel pump access hole cover panel

10Plates.JPG
1080 hits | 40.88 KB | Posted: 4/6/06
$40 shipped by USPS Priority in the US. 0 available as of 7/20/8. For info on purchasing one, read...