TSB97-03-10Fig9.JPG
567 hits | 26.62 KB | Posted: 12/21/06
Publication Date: FEBRUARY 3, 1997

LIGHT TRUCK:
1980-96 BRONCO, F-150, F-250 LD
1980-97 F-250 H...

TSB97-03-10Fig1.JPG
286 hits | 12 KB | Posted: 12/21/06
3. INSPECT FRAME BOLTS FOR PROPER INSTALLATION TORQUE

Inspect and tighten all front end component...

TSB97-03-10Fig2.JPG
207 hits | 11.36 KB | Posted: 12/21/06
Knock the rivet pin out of the blind side with a 6.35mm (1/4") drift punch and hammer (Figure 2).
...

TSB97-03-10Fig3.JPG
189 hits | 11.01 KB | Posted: 12/21/06
> Cut the rivet's head off with a hammer and flat chisel (Figure 3).

Click "Next" beside the ima...

TSB97-03-10Fig4.JPG
185 hits | 10.02 KB | Posted: 12/21/06
> Knock the sleeve out of the blind side with a 9.525mm (3/8") drift punch and hammer (Figure 4).
...

TSB97-03-10Fig5.JPG
313 hits | 41.32 KB | Posted: 12/21/06
2. After removing the rivet, verify the noise came from this location by pounding a wedge between th...

TSB97-03-10Fig6.JPG
194 hits | 42.73 KB | Posted: 12/21/06
5. Install a 9/16" Grade 8 torque prevailing Nut (34990-S2) with a Washer (44880-S2) and a Grade 8 B...

TSB97-03-10Fig7.JPG
268 hits | 29.33 KB | Posted: 12/21/06
a. Slide the bolt and washer into the "window" opening on the outside of the frame siderail, and ins...

TSB97-03-10Fig8.JPG
207 hits | 30.35 KB | Posted: 12/21/06
a. Torque all three (3) bolts/nuts at the crossmember-to-frame siderail at the wraparound side (Figu...

TSB97-03-10Chart1.JPG
189 hits | 24.66 KB | Posted: 12/21/06
a. Torque the gusset-to-frame bolts (Figure 8, Number 1).

b. Torque the crossmember-to-frame bolt...

TSB97-03-10Chart2.JPG
175 hits | 82.21 KB | Posted: 12/21/06
Warranty LABOR ALLOWANCE

Click "Next" beside the image above to continue.

TSB97-03-10Chart3.JPG
209 hits | 24.18 KB | Posted: 12/21/06
DEALER CODING
OASIS CODES: 305000, 390000, 702000, 702100

Click "Next" beside the image above t...