SuperMotors SuperMotors SUPERMOTORS Search — try “orange Bronco on 35s”
Join
Home/ Registry/ Ford/ Bronco/ 1980–1986/ “Eddie Bauer”/ New hood supermotors.net/registry/4970/20963

Album section

New hood

From 1986 Ford Bronco “Eddie Bauer” — documented by Sixlitre.

11 photos
← Back to this vehicle
1986 Ford Bronco - The last panel required and I'm new all round; hood, fenders, door shells, tailgate shell, rear quarters and under grill piece. All for les… 1986 Ford Bronco - Metal everywhere the original had metal and bracing just the same places too. 1986 Ford Bronco - Remove hood bolts and transfer U-nuts over to new hood. Disconnect underhood light, ground strap and........ 1986 Ford Bronco - Removed old hood latch tension strap from old hood and reinstalled it on new hood. DO NOT do this until you are absolutely satisfied with t… 1986 Ford Bronco - Hood off, cleaning hinges for paint with hood. Good time to remove or tweak cowl panel if you need to. 1986 Ford Bronco - New hood on pretty close, just a few tweaks left so she sits perfectly. Can't do that until I raise the entire passenger's fender a smidgeo… 1986 Ford Bronco - Old hood destined for junkyard. Not that bad, but enough rust starting and one or two dents to fix. Just can't justify fixing it when a new… 1986 Ford Bronco - Even though the sides and lines line up well, you can see there's a problem with the valance or cowl panel sticking up WAY too high over th… 1986 Ford Bronco - This under panel was pretty rusty, though curiously the rest of the areas under there were completely rust free. Luckily I scored one of th… 1986 Ford Bronco - Bad angle for the shot as it doesn't show how much closer the valance lines up with the new hood(look past my paw). As an added bonus the v… 1986 Ford Bronco - There's a better shot. Lined up flush and ready for final paint. BTW I got it flush by beating down the center hump under the valance with…