Service Procedures — Ford Bronco 1966-1977
Technical Reference
Member-uploaded diagrams & documents for this generation. AI-classified; community-verified where badged.
Service Procedures
- Manual-shift transmission reassembly page (p.6-24): set front output shaft end play to 0.003-0.005 in via shim pack, install idler gear/thrust washers and new O-ring on front output shaft flange.
- Manual-shift transmission overhaul page (Group 6, p.6-22) covering input shaft, rear drive output shaft and adapter housing teardown; output shaft inner bearing replaced with tool T56T-4616-A2.
- Service procedure page detailing 4-wheel drive transfer case major repair disassembly steps with labeled photographs.
- Manual-shift transmission/transfer case service page: describes power flow to front and rear axles and step-by-step transfer case removal and installation procedure with a fabricated input-shaft holding tool.
- Service manual page covering 4-wheel drive transfer case description and operation with a cutaway gear train figure.
- Service procedure page showing transfer case input and output shaft disassembly figures alongside assembly instructions.