Service Procedures: Ford F-150 1992-1996

Technical Reference

Member-uploaded diagrams & documents for this generation. AI-classified; community-verified where badged.

Service Procedures

• Service steps for oiling the Marzocchi fork foam/felt ring with SAE7.5w suspension oil, plus a 2013 note that new forks have no foam ring.
• Ford EEC-IV 60-Pin Connector Diagram - Mass Air Conversion Steps 7-8
  This document is a page from a Mass Air conversion instruction sheet (a service procedure for converting a Ford speed-density EFI system to mass air flow metering). It shows a large color illustration of the 60-pin EEC…
• Ford EEC-IV 60-Pin Connector Diagram - Mass Air Conversion Steps 7-8
  This document is a page from a Mass Air conversion instruction sheet (a service procedure for converting a Ford speed-density EEC-IV engine computer system to a Mass Air Flow system). The page features a color diagram…
• Ford Racing Idle Setting Procedure - IAC, TPS Voltage & Base Idle Adjustment
  This is a one-page Ford Racing technical bulletin titled "Idle Setting Procedure," describing a nine-step sequence (plus one sub-step) for setting engine idle on Ford fuel-injected engines. The document emphasizes that…
• Ford Rear Axle Unit-Bearing (TSU) Installation Instructions - Grease & Oil Lube
  This is a manufacturer's instruction sheet (printed in English, French, and Spanish) for installing a pregreased 'unit-bearing' (TSU-type sealed rear axle wheel bearing) on automotive rear wheel applications. It…
• Timken #12319-0386 trilingual instructions for removing and installing an automotive rear wheel unit bearing, with a cutaway diagram and warnings.
• Twelve-step Marzocchi 44 RLO/44 TST fork air travel change using spacer (40) and cir-clip (39); foot nuts torqued to 11NM. Spacer part Y536181.
• MAF conversion notes listing pin-out changes from a 1993 SD harness to a 1995 MAF EEC, injector lay-over harness moves and grey to black TFI pin wire changes.
• Installation instructions for a grille on a 1999-04 Ford F-250/F-350 pickup, covering grille shell removal, trimming and reattachment with a cutout diagram.