the original seat mounting bracket was at an angle, so I made a couple relief cuts and bent it flat. Welded the .188 wall tubing to it. Owner
Made 2 rows of tubing for a total of 3" lift under the seat. The two rails that run front-to-back are what actually mount to the body. Owner
2" angle iron welded along the back of the seat rails to give stability and a way to bolt the seat in. Owner
1/4" flat stock was welded from front to back to provide some more support. The Honda seat mounting brackets are not very strong. Owner
Front mounting brackets welded in place. Owner
Pass seat bolted in. Lots of clearance behind it for seat adjustment. Owner
Install complete. Owner
Front seat mounting location very close to where the original bench seat holes are. Owner