SuperMotors SuperMotors SUPERMOTORS Search: try “orange Bronco on 35s”
Home/ Registry/ Ford/ Bronco/ 1980-1986/ “1BadBronco”/ other vehicles supermotors.net/registry/1967/13294

Album section

other vehicles

From 1981 Ford Bronco “1BadBronco”, documented by Matt Kenney.

19 photos
1981 Ford Bronco - cool exhaust tip... a lot better then 2" pipe bent up so it is barely open 1981 Ford Bronco - Flowmasta!!! (40 series) 1981 Ford Bronco - the new pipe in front of muffler was a 5" long exhaus leak 1981 Ford Bronco - ripped off all the junk and putting on a 600 CFM Edelbrock and a new temp gauge and belts too 1981 Ford Bronco - pic before the ripping off of the extra weight and extra vacumm leaks. 1981 Ford Bronco - why I hate Edelbrock carbs. This was why my car idled like crap, didnt start but after 5 times and got horrible gas mileage. 1981 Ford Bronco - It was like this when we unbolted it, no human error caused this. Just stress or the cold 1981 Ford Bronco - pic with intake and drivers side valve cover off. The other side we had to cut the exhaust warmer thing off. 1981 Ford Bronco - everythings off, it doesnt look bad in here except the drivers side has a lot of carbonized oil all over it. I later noticed on the intake… 1981 Ford Bronco - cleaned up Edl performer intake. 1981 Ford Bronco - cleaning off the remaining crap with carb cleaner and a clean rag. 1981 Ford Bronco - applyed gasket shalac to all but the ends and the water passages. 1981 Ford Bronco - did the same to the engine side 1981 Ford Bronco - High temp RTV on the ends and water ports 1981 Ford Bronco - and again on the intake 1981 Ford Bronco - stuck the gaskets to the intake minus the ends and pressed it into place. Then installed a few bolts till the contacted the intake. Put the… 1981 Ford Bronco - ford blue.. it was either that or aluminum colored. I just quickly sanded it down and threw 2 coats on. 1981 Ford Bronco - all back together, new is the Performer intake, 600 CFM holley, distributor from an 80' Blazer, and Accell coil 1981 Ford Bronco - glamor shot of the new distributor. Oh and I removed a bunch more smog stuff and put on new heater hoses