CIMG0494.JPG
426 hits | 111.67 KB | Posted: 4/5/09
rusted through

CIMG0495.JPG
407 hits | 94.05 KB | Posted: 4/5/09
You will need to remove the seat risers.

CIMG0497.JPG
432 hits | 96.07 KB | Posted: 4/5/09
If they are ok and your careful in the cutting you can reuse them

CIMG0498.JPG
519 hits | 104 KB | Posted: 4/6/09
seat riser removed

CIMG0502.JPG
516 hits | 92.39 KB | Posted: 4/6/09
rear cut cleaned up and ready

CIMG0499.JPG
448 hits | 95.28 KB | Posted: 4/6/09
Rear first cut. Always cut on the panel side of the seam and clean it up later

CIMG0501.JPG
500 hits | 97.64 KB | Posted: 4/6/09
Cut around frame rail and crossmember support and clean up after

CIMG0507.JPG
532 hits | 98.46 KB | Posted: 4/6/09
Frame rail etc cleaned and ready

CIMG0503.JPG
532 hits | 88.88 KB | Posted: 4/6/09
Rocker rail clean and ready

CIMG0505.JPG
517 hits | 83.03 KB | Posted: 4/6/09
New floor section

CIMG0508.JPG
428 hits | 97.09 KB | Posted: 4/6/09
Tack everything first

CIMG0509.JPG
556 hits | 85.08 KB | Posted: 4/6/09
tack everything first

CIMG0496.JPG
661 hits | 86.35 KB | Posted: 4/5/09
passenger side complete