SuperMotors SuperMotors SUPERMOTORS Search: try “orange Bronco on 35s”
Join
Home/ Registry/ Ford/ Bronco/ 1992-1996/ 1992 Bronco/ E4OD homemade tools supermotors.net/registry/25289/80776

Album section

E4OD homemade tools

From 1992 Ford Bronco, documented by ghettoscrap.

12 photos
← Back to this vehicle
1992 Ford Bronco - Here is the end of the spring compression tool for removing the snap rings inside of drums, or this one can actually be turned around to pu… 1992 Ford Bronco - I forgot what this tool is called but it pushes the center support into the case so it can be bolted in place adn to set the rear clearance… 1992 Ford Bronco - Another shot of the mount and the engine stand, It holds better than I thought, I am not sure why they have a four post, two leg stand for… 1992 Ford Bronco - Transmission housing and associated rusty metal parts in a workshop setting. 1992 Ford Bronco - detail of the rear of the fixture showing washers used as spacer between the fixture and case 1992 Ford Bronco - Custom made transmission holding fixture that uses any standard engine stand as a base 1992 Ford Bronco - Detail of the welds at the pivot point, ugly but meaty! 1992 Ford Bronco - here is the fixture end of the spring compression tool where the fingers can slide into any width needed. 1992 Ford Bronco - close up of the fingers on the bar stock, the fingers where just cut out of bar stock as well. The shaft is just come big fat all thread. 1992 Ford Bronco - close up of the finger where it contacts the spring retainer in the hubs/cases. They are cut from some pipe, about 4 inch I think. 1992 Ford Bronco - another detail of the finger and the nasty torch cut that got it notched. 1992 Ford Bronco - detail of the nut and bar stock twisty thing for compressing the spring to allow snap ring removal.