How-to
1990 Ford F-250 Front and Rear Leaf Spring Swap With Leveling Kit
The front leaf springs on a 1990 Ford F-250 were replaced with F350 solid axle front springs, a leveling plate stack and drop brackets to gain upward wheel travel, followed by a drop pitman arm to correct the steering geometry. The rear springs, shackles and hardware were swapped at the same time for stiffer springs.
-
Step 1
Inspect the front leaf springs after offroad use. The front passenger leaf spring is broken and the other is bent, so both front springs need replacing.
-
Step 2
Measure the upward wheel travel on the stock suspension with a tape against the bump stop. Only a small amount of travel is left, and the truck hits the bump stop constantly offroad, which is the reason for a small front lift.
-
Step 3
Get the replacement springs. F350 solid axle front springs go on the front of this F-250 and heavier F250 rear springs go on the back, all ordered together on one freight shipment.
-
Step 4
Lay out the rest of the parts before starting: the new front springs, a leveling plate kit with U-bolts, drop brackets and the hardware.
-
Step 5
Compare the new F350 solid axle spring against the original light duty spring. The new spring is taller out of the box, and a plate on its bottom comes off, which leaves the height that adds wheel travel.
-
Step 6
Remove the factory plate and stack the leveling plates on the spring to set the ride height, checking the stack height with a tape. A taller stack lifts the front further, and the front then sits higher than the rear.
-
Step 7
Install the new front springs with the leveling plates, drop brackets and new bump stops, running the U-bolts around the axle. The front drop bracket goes in smoothly; lining up the centering pin with the hole in the axle is the hardest part of mounting the axle to the springs.
-
Step 8
Set the removed original springs aside.
-
Step 9
Realign the front end after the lift, then fit a drop pitman arm to bring the steering geometry back near factory. The photos show the axle and steering linkage from underneath. The drop pitman arm is used before any tie rod flip because the springs could otherwise contact the tie rods during articulation.
-
Step 10
Swap the rear springs, shackles and hardware. The original light duty rear springs come out for stiffer F250 springs that have less arch but more thickness, and the old rear spring bolts are replaced with new ones.
-
Step 11
The finished truck sits on its new front and rear springs. No further steps are documented.
Some product links go to the supplier the owner bought from. SuperMotors does not earn a commission today; if that changes, this line will say so and creators will be paid from it.