“El Jefe”1979 Ford Bronco

2x6 boards secured to garage ceiling joist using lag bolts. All cables route to pulleys that tie into a single cable on a remote controlled… Owner Pulled the push bar from a '79 F-250 at a junkyard. Stripped the chrome off of it, replaced a bent bar with a new 3/16 bar and painted with… Owner Let there be light! Owner Got 3 KC Daylighters and 2 KC driving lights with extra wiring harnesses for $100. Owner New back-up lights. Owner Used from quick disconnects for the back of the toggle switches. Owner Bought some toggle switches from eBayAmazon and mounted them in the visor area of the new headliner I got from LMC. Owner Mounted some Pro-Comp LED Spot Lights, ran wires alongside speakers wires through the doors. Owner Build a relay panel from a sheet of steel from Lowes. Painted it with left over engine paint from my transfer case rebuild. Owner Installed a fuse panel from Blue-Sea for all my new wiring. Mounted under the hood next to the brake booster. Owner 2X2 SQUARE 3W LED SPOT PAIR Pro Comp Suspension | Part Number: EXP76407P Ordered from 4wheelparts.com $$$ Owner Installed some cheaper flood lights from Amazon in the frame rails next to the fuel tank. Ran wires through plastic sheathing up to the new… Owner Mounted a free Cobra Nightwatch CB into my old radio spot. Owner Wrapped the ground wire and antenna wire down and zip tied to the frame up to the unit. Owner Bent a CB Antenna mirror mount and attached to the spare tire holder. Owner Added a quick disconnect and spring. Owner Toggle switches mount great in the drivers side area. Could also be cut out for storage. Owner Mounted the new radio (with Bluetooth phone connectivity). Owner It took some trimming to make it fit but it looks great overall. It's much bigger than the stock headliner. The speakers could be better an… Owner I got the models with the build in 80-watt 6x9 speakers. They sound great and are marine grade so they should hold up well when the top's o… Owner This is a work in progress project. I ordered two of these VDP boxes from JEGS and plan to install them in the rear once I finish my fiberg… Owner Not allot to show here. Got the 3G unit from a '94 Taurus, Reworked the wiring and added a 150-amp breaker into the mix. Owner Scored a great engine bay light off of an old Chevy at a junkyard, The cord extends out to 20 foot and then reels back in. Owner Toggle switches Owner