Firewall.jpg
658 hits | 40.47 KB | Posted: 6/11/12
firewall leak right below the panel that the steering shaft goes through.,

firewall.jpg
582 hits | 45.84 KB | Posted: 6/12/12

firewall2.jpg
559 hits | 52.82 KB | Posted: 6/12/12

IMG_6728.JPG
553 hits | 47.09 KB | Posted: 6/26/12

IMG_7900.JPG
528 hits | 51.55 KB | Posted: 1/1/13
inside the firewall where the brake booster comes through. looks like this is rusted out. Somehow wa...

IMG_7904.JPG
491 hits | 53.74 KB | Posted: 1/1/13

IMG_7902.JPG
528 hits | 54.99 KB | Posted: 1/1/13

IMG_7903.JPG
502 hits | 51.91 KB | Posted: 1/1/13

IMG_7862.JPG
461 hits | 52.09 KB | Posted: 2/17/13

IMG_7860.JPG
543 hits | 62.63 KB | Posted: 2/17/13
needed to get these wires through the firewall, got a hole saw and opened up the clutch plate blank,...

IMG_7861.JPG
477 hits | 58.64 KB | Posted: 2/17/13

20140222_100216.jpg
374 hits | 55.43 KB | Posted: 2/24/14

20140222_102151.jpg
376 hits | 40.91 KB | Posted: 2/24/14

20140301_132154.jpg
407 hits | 48.18 KB | Posted: 3/7/14
pulled the cowl, this is what the trough looks like. I'm not sure where the seams are that go down a...

20140301_132203.jpg
379 hits | 52.77 KB | Posted: 3/7/14
this is the trough before I re-sprayed it.

20140301_140503.jpg
379 hits | 55.11 KB | Posted: 3/7/14
this small hole, which I'm pretty sure it there to drain water into the trough is underneath the win...

20140301_140508.jpg
392 hits | 46.71 KB | Posted: 3/7/14

20140301_140523.jpg
402 hits | 61.51 KB | Posted: 3/7/14
this is the trough after I sprayed it again with the flex seal material. this initial application di...

20140317_092741.jpg
375 hits | 48.76 KB | Posted: 3/19/14
it poured again...

floorboard.jpg
394 hits | 105.12 KB | Posted: 3/19/14
and there is the water...so either I didn't seal the trough good enough or the leak is coming from s...

20140320_140044.jpg
386 hits | 60.72 KB | Posted: 3/21/14
getting ready to replace the windshield for the 2nd time in the last 2 years. this time the guy remo...

20140320_140046.jpg
382 hits | 61.1 KB | Posted: 3/21/14
you can see in the upper right hand corner what looks like rust. it's doubtful, but maybe the water ...

20140329_073946.jpg
378 hits | 96.51 KB | Posted: 3/31/14
So after all that is still leaked. clearly my problem was not the windshield.

20140330_183820.jpg
397 hits | 64.99 KB | Posted: 3/31/14
I used a tube of the Dyantron seam sealer to try and address the leak..my assumption was that it was...

20140330_183827.jpg
380 hits | 73.4 KB | Posted: 3/31/14
used what was left of the dynatron grey seam sealer I had and spread it across every possible crease...

20140330_183830.jpg
379 hits | 71.48 KB | Posted: 3/31/14
this application of seam sealer was not nearly enough.

trough pic.jpg
371 hits | 61.09 KB | Posted: 3/31/14
got a as close to the drivers side fender as possible..it was difficult getting my arm in there...

20140416_080212[1].jpg
379 hits | 76.13 KB | Posted: 4/16/14
It poured yesterday and I mean torrential....the only thing the tarp did was keep the water off my b...

20140416_080247[1].jpg
406 hits | 78.32 KB | Posted: 4/16/14
no water under the floor mat.. it looks like I finally solved my firewall leak..

20140502_124658.jpg
398 hits | 72.12 KB | Posted: 5/2/14
That was short lived...the next rain the leak was back...

20140524_130418.jpg
388 hits | 58.33 KB | Posted: 5/27/14
This is a pic from inside the trough. That lip runs the length of the trough on the firewall, I'll s...

20140524_130427.jpg
360 hits | 71.8 KB | Posted: 5/27/14

20140524_131148.jpg
379 hits | 45.11 KB | Posted: 5/27/14

20140524_131156.jpg
350 hits | 41.81 KB | Posted: 5/27/14

20140527_184140 (1).jpg
376 hits | 69.56 KB | Posted: 5/27/14
still wet after the last application of seam sealer.

20140604_193931.jpg
338 hits | 58.25 KB | Posted: 6/5/14
got this brushable seam sealer and acid brushes from Eastwood. much cheaper than the stuff in the tu...

20140604_195820.jpg
373 hits | 58.08 KB | Posted: 6/5/14
mix it up really good before applying.

20140604_194035.jpg
375 hits | 42.18 KB | Posted: 6/5/14
I'm going to show how to remove the cowl to access the trough. First removed the windshield wipers.

20140604_194041.jpg
355 hits | 51.11 KB | Posted: 6/5/14
starting from the top, I remove these phillips screws that hold the cowl down. There are 5 of them t...

20140604_194046.jpg
339 hits | 70.87 KB | Posted: 6/5/14
you can see all of the holes for the cowl screws in this pic.

20140604_194404.jpg
365 hits | 42.17 KB | Posted: 6/5/14
then pop the cover off the antenna mount and remove the 4 screws, pull the antenna up and unplug the...

20140604_194617.jpg
363 hits | 43.71 KB | Posted: 6/5/14
remove the antenna cable

20140607_101219.jpg
399 hits | 53.13 KB | Posted: 6/7/14
now under the hood. on mine at least, there are 4 additional screws there are two at opposite ends a...

20140607_101155.jpg
377 hits | 56.56 KB | Posted: 6/7/14

20140607_101206.jpg
347 hits | 56.69 KB | Posted: 6/7/14

20140604_194643.jpg
389 hits | 51.26 KB | Posted: 6/5/14
only thing left is to disconnect the windshield washer hose. I cut mine in the middle and splice it ...

20140604_194838.jpg
369 hits | 45.13 KB | Posted: 6/5/14

20140604_194913.jpg
351 hits | 54.39 KB | Posted: 6/5/14

20140604_195157.jpg
373 hits | 53.44 KB | Posted: 6/5/14
and you're done..

20140604_195218.jpg
383 hits | 58.51 KB | Posted: 6/5/14
this pic is from the inside of the trough facing the firewall. The black stuff at the top is a putty...

20140604_195435.jpg
401 hits | 57.01 KB | Posted: 6/5/14
over the years, I'm sure it has started to deteriorate. I'm going to cover the entire area with a lo...

20140604_195518.jpg
393 hits | 59.14 KB | Posted: 6/5/14
there you go...

20140604_195632.jpg
388 hits | 50.14 KB | Posted: 6/5/14

20140604_201127.jpg
365 hits | 65.83 KB | Posted: 6/5/14

20140604_201137.jpg
367 hits | 61.18 KB | Posted: 6/5/14

20140604_201245.jpg
379 hits | 65.23 KB | Posted: 6/5/14

20140604_201255.jpg
363 hits | 70.66 KB | Posted: 6/5/14
I went back an covered over this area again.

20140607_100956.jpg
372 hits | 52.6 KB | Posted: 6/7/14
Result of a heavy storm last night. Even after applying the seam sealer across the seam on the insid...

20140608_101004.jpg
364 hits | 47.42 KB | Posted: 6/8/14
This is a picture from inside of the trough. In addition to applying the seam sealer along the seam ...

20140608_094241.jpg
367 hits | 37.43 KB | Posted: 6/10/14
This is the area where the brake booster meets the firewall..I had pulled the booster and sealed it ...

20140608_150714 - Copy.jpg
369 hits | 38.27 KB | Posted: 6/8/14
we had some rain, nothing major, maybe a 15 or 20 minute shower, but the floor board stayed dry.

20140608_150709.jpg
371 hits | 87.19 KB | Posted: 6/8/14

20140609_183602.jpg
361 hits | 64 KB | Posted: 6/10/14
got a pretty decent down pour. I'd say 30 to 45 minutes of heavy rain.

20140609_183711.jpg
359 hits | 54.15 KB | Posted: 6/10/14
from the inside watching the rain come down...

20140609_183741.jpg
359 hits | 85.83 KB | Posted: 6/10/14
floor board is dry.

20140706_153539.jpg
368 hits | 55.28 KB | Posted: 7/7/14
Determined to find the leak, I sprayed the hose in the spot I thought it was most likely coming from...

20140706_153607.jpg
369 hits | 58.44 KB | Posted: 7/7/14
The water was being sprayed across the top of the brake booster and near the clutch plate cover.

20140706_155903.jpg
388 hits | 62.59 KB | Posted: 7/7/14

20140707_180915.jpg
403 hits | 83.17 KB | Posted: 7/8/14
Water dripping down after spraying around the brake booster.

20140707_180930.jpg
383 hits | 70.31 KB | Posted: 7/8/14

20140707_192603.jpg
431 hits | 51.02 KB | Posted: 7/8/14

20140707_192609.jpg
396 hits | 37.31 KB | Posted: 7/8/14
top of the brake booster where it meets the firewall. this is the suspect area,

20140707_193544.jpg
417 hits | 49.82 KB | Posted: 7/8/14
after applying a copious amount of seam sealer across the top of the brake booster, the leak has gon...

IMG_20181224_123942653_HDR.jpg
405 hits | 58.54 KB | Posted: 1/8/19

IMG_20181225_113917215_HDR.jpg
576 hits | 63.71 KB | Posted: 1/8/19