Drop Hitch

This is what I am going to use to make a new drop hitch to go with the new rear bumper Owner First piece cut, clamped in the receiver so I can drill the hole for the pin Owner Here I am eyeballing the next piece to get it straight before I weld it Owner Tack weld Owner Close up, I beveled the miter for maximum penetration of the weld. I also preheated it with a propane torch Owner After welding the mitered joint, I added a gusset for strength Owner A little paint Owner Had to make some 3/4" material for the bottom Owner Turned out pretty good Owner All finished, 17.5" drop Owner