michael collins > 1983 Ford Bronco > open folder Pivot Bushings

Here is the stock pivet mount bushing (i was replacing the TTB drop mount so it is not in the pictur...
axle mount.jpg
1335 hits | 96.15 KB | Posted: 11/9/06
Here is the stock pivet mount bushing (i was replacing the TTB drop mount so it is not in the pictur...
Here was the old pivet mount. they tack welded it in place.
pivot mount bottom.jpg
1211 hits | 66.87 KB | Posted: 11/9/06
Here was the old pivet mount. they tack welded it in place.
the old mounts do not come out too easy. i used the drill many holes in the rubber and then an air c...
piviot-mount.jpg
1107 hits | 67.16 KB | Posted: 10/27/06
the old mounts do not come out too easy. i used the drill many holes in the rubber and then an air c...
I did the bushings on the bronco. i put the jack stand on the outer axle and used the floor jack as ...
setting the jack stand.jpg
1538 hits | 103.68 KB | Posted: 11/1/06
I did the bushings on the bronco. i put the jack stand on the outer axle and used the floor jack as ...
Here is the tool you will want to get if you are installing new bushings. i could have used this to ...
c-press.jpg
1311 hits | 70.39 KB | Posted: 10/27/06
Here is the tool you will want to get if you are installing new bushings. i could have used this to ...
This is after i drilled out the rubber and used the air hammer to punch out the shell.
driver axle.jpg
1368 hits | 102.66 KB | Posted: 11/9/06
This is after i drilled out the rubber and used the air hammer to punch out the shell.
Here is the new bushing installed and ready to go in the new mount.
piovyt-mount2.jpg
1305 hits | 65.05 KB | Posted: 10/27/06
Here is the new bushing installed and ready to go in the new mount.
Here is a close up of the new bushing.
axle mount.jpg
1829 hits | 81.56 KB | Posted: 11/1/06
Here is a close up of the new bushing.