SuperMotors SuperMotors SUPERMOTORS Search: try “orange Bronco on 35s”
Join
Home/ Registry/ Ford/ Bronco/ 1980-1986/ “Jezebel”/ Springs supermotors.net/registry/6364/53142

Album section

Springs

From 1983 Ford Bronco “Jezebel”, documented by michael collins.

22 photos
← Back to this vehicle
1983 Ford Bronco - Here is the driver side as i started. These are superlift 4" lift springs. 1983 Ford Bronco - here is another view of the way she looked when i started. 1983 Ford Bronco - Here is the starting point. 40" at the start. 1983 Ford Bronco - another shot of the starting point. 40 inches from the ground. 1983 Ford Bronco - Here is the 40 inches from ground on the pass side at the start. 1983 Ford Bronco - Here is the pass side at the start 1983 Ford Bronco - The swap is sorta easy and fast. i removed the top of the shock and the top coil keeper and the bottom 1 1/8 nut on the retainer. i then dr… 1983 Ford Bronco - Here is the new coil in the pass side and bolted in. i still need to secure the shock. 1983 Ford Bronco - Here is the driver side spring out. 1983 Ford Bronco - Here is the driver side all completed. 1983 Ford Bronco - Here are the old coils. still in good shape. 1983 Ford Bronco - Here are the new springs fresh off ebay. 1983 Ford Bronco - here is the new coils. all shinny and rear to goto work. 1983 Ford Bronco - here is the drivers side spring with the new spring. 1983 Ford Bronco - here is the pass side new and old spring. 1983 Ford Bronco - Here she is ready to got for the front end alignment. 1983 Ford Bronco - She now sitting alot more level. 1983 Ford Bronco - She is looking great. no more jacked up rear end... 1983 Ford Bronco - She is all done for now. 1983 Ford Bronco - i got her leveled but now the wheels look like \---------/ not |----------| the ttb mounts wer only for 4" not the 6" i got now. well new m… 1983 Ford Bronco - Final measure after the springs were installed....almost 43 inches on the drivers side. 1983 Ford Bronco - if i remove the swaybar i get almost 45 inches. i think i need to look into this issue.