1978 Ford Bronco
Owner: LadyBronc 
From: Veneta, OR, U.S.A.        (Other registries in OR)
Year, Make, & Model: 1978 Ford Bronco        (Other Ford Broncos)
Avatar:
Nickname:
Mileage:
Engine:
Drivetrain:
Notes:
Last Updated: 3/27/2005
Hits: 3654
Album
Folder Hits Comments Created Updated
folder 2-22-05 Just brought her home.12002,64402/26/052/26/05
folder 2-24-05.  Begining restoration.9002,27102/26/053/8/05
folder Brakes and Rotors6001,37303/8/053/8/05
folder Redneck Easter Egg Hunt18006,78903/27/053/27/05
Newest Media Files
DSCI0043.JPG
416 hits | 84.83 KB | Posted: 3/27/05

Nope! No eggs here either!
DSCI0040.JPG
419 hits | 55.98 KB | Posted: 3/27/05

Just shaken off the water.
DSCI0039.JPG
406 hits | 57.34 KB | Posted: 3/27/05

Bronco approaching the watering hole.
DSCI0034.JPG
385 hits | 71.83 KB | Posted: 3/27/05

DSCI0030.JPG
377 hits | 79.25 KB | Posted: 3/27/05

Nope! No eggs in there!
DSCI0024.JPG
398 hits | 65.03 KB | Posted: 3/27/05

DSCI0020.JPG
380 hits | 52.86 KB | Posted: 3/27/05

DSCI0017.JPG
400 hits | 48.99 KB | Posted: 3/27/05

DSCI0016.JPG
352 hits | 45.69 KB | Posted: 3/27/05

Most Viewed Files
DSCI0002.JPG
564 hits | 82.52 KB | Posted: 3/27/05

DSCI0003.JPG
428 hits | 62.24 KB | Posted: 3/27/05

Looking for the Great Easter Egg Hunting grounds.
DSCI0040.JPG
419 hits | 55.98 KB | Posted: 3/27/05

Just shaken off the water.
DSCI0043.JPG
416 hits | 84.83 KB | Posted: 3/27/05

Nope! No eggs here either!
DSCI0010.JPG
413 hits | 48.37 KB | Posted: 3/27/05

DSCI0039.JPG
406 hits | 57.34 KB | Posted: 3/27/05

Bronco approaching the watering hole.
DSCI0017.JPG
400 hits | 48.99 KB | Posted: 3/27/05

DSCI0024.JPG
398 hits | 65.03 KB | Posted: 3/27/05

DSCI0034.JPG
385 hits | 71.83 KB | Posted: 3/27/05

Maintenance & Modification Logs
DateTypeMileageTitle / Description$ Amount
03/08/05Repair Seat Repair
The seat recovering has begun!
I started with the back bottum seat figuring this was going to be the hardest out of all of them. I am taking my time so I can't really give you an estimate on how long this is taking, but all in all I was able to take the seats out of the Bronc in about a day.
I am reusing the existing vinal that was on the seats since there was only a couple of cracks in it. . . . this is saving money. Also I had purchased some fabric about 5 years ago at a salvage shop for $7. I ended up with 21 feet of it at that price, so it was definately a steal.
I started out the actual recovering by taking apart the fabric and cutting out the new piece in one day and then sewing in the new piece on the second day. I would say that have invested a total of about 4 hours into just one section of seat. Not bad really for the results and cost.

Check out the results in the RESTORATION section of my photo album.
12.00
02/24/05Maintenance Brake/ Rotor replacement.
Replaced the rotors and brakes today. The whole ordeal actually went well other then the wind desided to blow and rain started falling as we were replacing the last set of brakes. . .isn't that the way it goes!

All in all it went well. The passenger side was in great shape, but the driver side was the extreme opposite. . .groved badly. We were able to get the job done without too many problems and I was actually quite surprised considering how long we are thinking this poor girl sat and collected moss.

Well, she still isn't ready to run the roads. . . .we still have a brake fluid leak in the rear end, but NEXT on our list!
52.00
02/22/05Miscellaneous The Begining of a Project!
Ok. . .a little story on my Bronco.
I found her in the back corner of a tiny car lot in Springfield Oregon. The salesman stated that she was brought in as a trade in.
At first site it was hard to tell what was paint green and what was just plain green film from sitting. The interior doesn't look like its seen human life in over a year which is about how outdated the tags are on it. But with a little assistance from a jumper box she fired right up.
This is where everyone cringes at me. . . yes I paid $1000.00 for her and drove her home. She has a kick butt engine in here and the 4x4 is in great shape. By looking at the hay inside I would say that she spent her time hauling hay bails and not much more. . .but all in all the repairs that need to be done for her to be a safe running rig again are few.
New brakes and rotors.
New u-joints.
New battery.
Restore the interior!

Hopefully I will be documenting the brake and rotor soon!!

Feel free to send your cringes as well.. lol.
Thanks for reading.
0.00
Total64.00
About SuperMotors | Contact Us | FAQ/Help | Legal
Copyright © 1998-2022 Web Design Solutions, Inc.
All rights reserved. Duplication & reproduction is strictly prohibited.
SuperMotors.net v5.0.2 ChangeLog