SuperMotors SuperMotors SUPERMOTORS Search: try “orange Bronco on 35s”
Join
Home/ Registry/ Ford/ Bronco/ 1987-1991/ “The OJ Special”/ Transfer case linkage repair supermotors.net/registry/8571/50131

Album section

Transfer case linkage repair

From 1988 Ford Bronco “The OJ Special”, documented by Adrianspeeder.

13 photos
← Back to this vehicle
1988 Ford Bronco - 15mm shifter pivit arm bolt 1988 Ford Bronco - A red and black Husky air ratchet wrench with a brass quick-connect coupler and attached air hose, laid on flattened cardboard. It is a sho… 1988 Ford Bronco - A heavily rusted metal bracket with a bolt is shown close-up against a concrete surface. 1988 Ford Bronco - Close-up of a heavily rusted stamped-steel shift arm lying on a concrete slab, showing the pivot bolt hole and scaly orange corrosion acros… 1988 Ford Bronco - Overhead shot of a rusty shift arm on exposed-aggregate concrete, its flat blade held by a corroded slotted screw where the black-painted b… 1988 Ford Bronco - A shift arm cleaned back to bare metal at the pivot end lying on a concrete curb next to an air-powered die grinder with an abrasive bit, p… 1988 Ford Bronco - Close-up of a heavily rusted metal bracket with a worn rubber bushing, likely a vehicle part. 1988 Ford Bronco - Rusted transfer case linkage bracket, showing wear and corrosion. 1988 Ford Bronco - Tight underside shot of a rusty cast bracket and bolt being turned with a black-handled ratcheting wrench, with a red Husky-branded tool ha… 1988 Ford Bronco - Finally! 1988 Ford Bronco - Schematic of a transfer-case shifter gate from the driver side and rear, labeling shift positions and pivot bolt. 1988 Ford Bronco - Floor-level interior shot of a manual transmission shifter with a bent black lever and round knob rising from a ribbed rubber boot on gray… 1988 Ford Bronco - Close-up of a black transfer case shift knob with a white shift-pattern diagram showing 2H, 4H, N and 4L positions, mounted on a gray carpe…