What is this blueprint for?

It is a hand-drawn fabrication template for an E-brake (parking brake) cable bracket, showing a small square plate and a larger C-shaped plate with drilled holes and dimensions.

What material thickness is specified?

The drawing calls for 1/4" plate for both pieces.

How many holes are drilled in the large plate?

Three holes are shown — two along the left side and one at the lower right — each with a drill-size callout (appears to read 3/4").

What are the overall dimensions of the main plate?

Marked dimensions appear to be about 5-3/8" on the left side and 5-3/4" across the bottom.

What is done to the small square piece?

It is a roughly 1-1/2" x 1-1/2" piece of 1/4" plate labeled 'E-Brake Cable Bracket'; a hole is drilled in it and it is then cut to an angle, per the callout.

Home/ Registry/ Ford/ C-350 (Centurion Conversions)/ “Green”/ Photo supermotors.net/registry/media/762571

E-Brake Cable Bracket Template Blueprint - 1995 Ford C-350 Centurion

Hand-drawn dimensioned mounting plate template page 2 with hole locations and measurements

‹ ›

Hand-drawn dimensioned mounting-plate fabrication template, page two, with hole spacing and dimensions.

AI caption October 2009 · Photo 1790 of 1819

This document is a hand-drawn fabrication blueprint/template scanned from a paper sketch, uploaded to the gallery of a 1995 Ford C-350 Centurion Conversions vehicle. It shows two parts to be cut from 1/4-inch steel plate. The first is a small square piece (roughly 1.5" x 1.5") labeled as an E-brake (emergency/parking brake) cable bracket, with a hole to be drilled (appears to read 9/16") and then cut to an angle. The second, larger piece is a roughly C-shaped or horseshoe-shaped plate with a large curved cutout (labeled as a slot) and three drilled holes — two along the left edge and one at the lower right — each with drill-size callouts that appear to read 3/4". Overall dimensions marked appear to be about 5-3/8" tall and 5-3/4" wide. A reader can use this page as a cutting and drilling template for fabricating a parking-brake cable bracket assembly, presumably part of a multi-page template set (the album also contains a 'Complete Template' page). The handwriting is small and partially blurred, so specific fractions should be verified against the companion template page before fabrication.

Is this accurate? Sign in to help verify it.

Frequently asked questions

What is this blueprint for?: It is a hand-drawn fabrication template for an E-brake (parking brake) cable bracket, showing a small square plate and a larger C-shaped plate with drilled holes and dimensions.
What material thickness is specified?: The drawing calls for 1/4" plate for both pieces.
How many holes are drilled in the large plate?: Three holes are shown — two along the left side and one at the lower right — each with a drill-size callout (appears to read 3/4").
What are the overall dimensions of the main plate?: Marked dimensions appear to be about 5-3/8" on the left side and 5-3/4" across the bottom.
What is done to the small square piece?: It is a roughly 1-1/2" x 1-1/2" piece of 1/4" plate labeled 'E-Brake Cable Bracket'; a hole is drilled in it and it is then cut to an angle, per the callout.