SuperMotors SuperMotors SUPERMOTORS Search — try “orange Bronco on 35s”
Join
1984 Ford Bronco “Casual Mudder”
Home/ Registry/ Ford/ Bronco/ 1980–1986/ “Casual Mudder” supermotors.net/registry/1133

“Casual Mudder”1984 Ford Bronco

448 photos documented since 2003 7 years documented ♡ Follow this build

The story

Purchased vehicle from original owner in 8/01. New paint job 10/02 - PPG Ford medium blue metallic urethane and clear coat. S&W 10-pt roll cage kit, PRP Racing seats, RCI 5-pt harnesses, custom wiring harness, Tuffy console — Randy Zrubek

Day one vs. today

Drag to compare 2003 against 2010.

1984 Ford Bronco in 2010
1984 Ford Bronco in 2003
2003 2010

Photo history

448 photos across 8 years — drag the dot to travel through this vehicle’s life. Captions are the owner’s; where there isn’t one, the AI caption fills in.

2003

2003

64 photos added — showing 8

1984 Ford Bronco - 1984 FORD Bronco XLT 4X4 original condition 1984 Ford Bronco - front view, new paint job 1984 Ford Bronco - hood and grille 1984 Ford Bronco - Stull square-tube grille 1984 Ford Bronco - New grille and hdlight bezels 1984 Ford Bronco - 1984 FORD Bronco XLT 4X4 - original condition 1984 Ford Bronco - 1984 FORD Bronco XLT 4X4 - original condition 1984 Ford Bronco - side view, new paint job

2004

9 photos added — showing 8

1984 Ford Bronco - Laying a little rubber on a country road 1984 Ford Bronco - Shaker and lift kit installed 1984 Ford Bronco - mudpic1 1984 Ford Bronco - mudpic2 1984 Ford Bronco - 2004 TX Heatwave, Austin, TX 1984 Ford Bronco - 2004 TX Heatwave, Austin, TX 1984 Ford Bronco - 2004 TX Heatwave, Austin, TX 1984 Ford Bronco - 2004 TX Heatwave, Austin, TX

2005

127 photos added — showing 8

1984 Ford Bronco - First remove seats, seatbelt anchors, console, stereo amps, CB, etc. Found $2.59 in change! 1984 Ford Bronco - After pulling up carpet, check floorpan for cracks or rust. Good shape here. 1984 Ford Bronco - A non-poisonous snake has round eyes, but you have to get close to see them! 1984 Ford Bronco - floor plate for main hoop. The seatbelt assly is coming out, just left it in to show location of plate. 1984 Ford Bronco - 1/8" floor plate bent to fit contour of floor. I used a BFH & a vise. 1984 Ford Bronco - floor plates for windshield post runners, or front downbars next to dash. 1984 Ford Bronco - location of front runner floor plate. This will be tied into the frame later with a plate and tubing underneath. 1984 Ford Bronco - I used a chop saw to cut the tubing. Some items need triming. I also used a handheld grinder to notch any ends.

2006

147 photos added — showing 8

1984 Ford Bronco - front crossmember below motor, very dirty!!! 1984 Ford Bronco - cleaned and brushed with Ospho, then primer applied next day 1984 Ford Bronco - DupliColor Spray-on Bedliner applied to primered frame parts 1984 Ford Bronco - Front crossmember done!!! 1984 Ford Bronco - front bumper and core support bushings removed, frame horns primered and painted 1984 Ford Bronco - Front / radiator core support mount and poly bushings 1984 Ford Bronco - preparing for front clip removal, frame restore 1984 Ford Bronco - rear frame, Ospho applied

2007

37 photos added — showing 8

1984 Ford Bronco - frame notched for oil filter adapter bolt 1984 Ford Bronco - frame notched for oil filter adapter 1984 Ford Bronco - long oil filter hits steering box 1984 Ford Bronco - C-6 tranny install 1984 Ford Bronco - 36" Goodyear RT II's on 16.5" Hummer rims (frosty) 1984 Ford Bronco - tranny crossmember and 78/79 Bronco poly bushings installed 1984 Ford Bronco - remove hinge and place in vice 1984 Ford Bronco - grind off lip of stock pin

2008

34 photos added — showing 8

1984 Ford Bronco - JEG's tool kit, some old tools, clamps, files, etc. 1984 Ford Bronco - Instructions 1984 Ford Bronco - Tubing cutter 1984 Ford Bronco - deburring line with 7/64" drill bit, chamfer end with file, put clamp in vise to hold line 1984 Ford Bronco - Set depth of line in clamp using the adapter 1984 Ford Bronco - Put fitting on line, then put tool on clamp and tighten 1984 Ford Bronco - Vise used to hold clamp 1984 Ford Bronco - Tighten until adapter bottoms out on clamp

2009

11 photos added — showing 8

1984 Ford Bronco - rear driveshaft installed 1984 Ford Bronco - notched tranny crossmember for front driveshaft 1984 Ford Bronco - stock front driveshaft installed 1984 Ford Bronco - This blue Ford Bronco appears to be from the early 1980s, a lifted suspension and oversized tires. 1984 Ford Bronco - Modified blue pickup truck with roll cage and large tires, parked outdoors. The vehicle appears to be a Ford Bronco from the early 1980s. 1984 Ford Bronco - This modified SUV features a prominent roll cage and off-road tires, suggesting it's built for terrain. 1984 Ford Bronco - A blue Ford Bronco sits in a field with its doors open, showing off its lifted suspension and aftermarket grille. 1984 Ford Bronco - This Ford Bronco features a heavy-duty brush guard and an aftermarket grille, with another vehicle visible to the side.

2010

16 photos added — showing 8

1984 Ford Bronco - Close-up view of a custom brush guard mounted on a vehicle, showing its construction details. 1984 Ford Bronco - Close-up of the front brush guard and radiator assembly on a 1984 Ford Bronco. 1984 Ford Bronco - Brush guard mounting hardware attached to vehicle frame. 1984 Ford Bronco - This Ford Bronco features a custom brush guard and a Skyjacker decal on the windshield. 1984 Ford Bronco - Close-up of a vehicle's wheel and tire assembly, showing a silver alloy rim and a large black tire. 1984 Ford Bronco - Close-up view of a silver wheel, identified with the marking 'CEQ'. 1984 Ford Bronco - Interior view showing a large spare tire and roll cage structure. 1984 Ford Bronco - Ford Bronco with custom front bumper and large tires parked on grass.
Browse all 448 photos Album view

The peanut gallery

No comments yet — be the first to add to the record.

Spotted in the wild

Seen this vehicle at a show or on the trail? Add your shot — the owner approves it onto the record.