SuperMotors SuperMotors SUPERMOTORS Search — try “orange Bronco on 35s”
Join
Home/ Registry/ Ford/ Excursion/ 2000–2005/ “The Excursion”/ Dana 50 Front Hub/Bearing Replacement supermotors.net/registry/9/54748

Album section

Dana 50 Front Hub/Bearing Replacement

From 2000 Ford Excursion “The Excursion” — documented by E. Long.

8 photos
← Back to this vehicle
2000 Ford Excursion - I had a lot of play in the front passenger-side wheel and it was due to the bearing in the hub assembly being worn out. The swap is very st… 2000 Ford Excursion - Brand new Dana 50 hub assembly. Front axle bearings in the Dana 50 are non-serviceable, so when the bearing fails, you have to purchase the… 2000 Ford Excursion - Same hub assembly without the plastic plug. 2000 Ford Excursion - The old hub assembly. Notice the 4 studs (threaded on each end). The studs feed through the holes in the steering knuckle and have 4 bolts… 2000 Ford Excursion - Dana 50 front hub assembly, likely from a 4x4 truck or SUV, showing wear and grease. 2000 Ford Excursion - Notice the yellow o-ring (Part # F81Z-4A322-AA ) and how it is shredded. Do not expect to be able to re-use this o-ring. Plan ahead and pic… 2000 Ford Excursion - Close-up of the front passenger knuckle with wheel, caliper, hub assembly, and brake dust shield removed. 2000 Ford Excursion - The entire hub assembly swap will take 60-90 minutes and is very straight-forward. Remove the retaining/c-clip from the hub http://www.supe…