SuperMotors SuperMotors SUPERMOTORS Search: try “orange Bronco on 35s”
Join
Home/ Registry/ Ford/ Bronco/ 1992-1996/ “Labor of Love”/ broken Ring/pinion in 8.8 supermotors.net/registry/17883/71239

Album section

broken Ring/pinion in 8.8

From 1996 Ford Bronco “Labor of Love”, documented by DNBELOWBRONCO.

14 photos
← Back to this vehicle
1996 Ford Bronco - So I had 4.56 gears put in my 8.8 and broke it in the required 500 miles, the right way, and drained and filled the diff up and headed to t… 1996 Ford Bronco - Ground down the ring teeth a little.... 1996 Ford Bronco - Lucky me this is the side the cross pin has to come out of....would be nice if it was a "Round" hole..... 1996 Ford Bronco - Rear axle housing with the differential cover removed, showing the oily ring gear, carrier, spider gears and a limited-slip S-spring clip i… 1996 Ford Bronco - Flat teeth make it kinda hard for the "speed sensor" to read as it spins around.... 1996 Ford Bronco - The pinion gear rolled over this like a toothed steam roller...... 1996 Ford Bronco - This side does not look too bad, of course this is where you push the cross pin through, then spin the case 180* and pull it out the opposi… 1996 Ford Bronco - Broke the case right off the ring gear....... 1996 Ford Bronco - Limited slip clutches are all mashed into each other..... 1996 Ford Bronco - Here's the case in 2 halfs.....the piece on the right should be attached to the ring gear on the left........ 1996 Ford Bronco - Up above you can see where it broke off...... 1996 Ford Bronco - Here's the 1/2 of the case that holds the limited slip clutches.... 1996 Ford Bronco - Here's the pinion aka "The Toothed Steam Roller"..... 1996 Ford Bronco - Oily close-up inside an open differential showing the splined side gear and spider gears in the carrier, with the ring gear teeth wrapping…